Skip to content

K
Kernel

openeuler / Kernel
1 年多 前同步成功

通知 8
Star 0
Fork 0
K
Kernel
切换分支/标签
  1. 03 11月, 2010 3 次提交
  3. 13 8月, 2010 2 次提交
    • R
      ALSA: ISA: Remove snd-sgalaxy · cbaa9f60
      由 René Herman 提交于 
      Its hardware is handled more fully by the new azt1605/azt2316 drivers.
Signed-off-by: NRene Herman <rene.herman@gmail.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
      cbaa9f60
    • R
      ALSA: ISA: New Aztech Sound Galaxy driver · 49531192
      由 René Herman 提交于 
      This is a new driver for Aztech Sound Galaxy ISA soundcards based on the
AZT1605 and AZT2316 chipsets. It's constructed as two seperate drivers
for either chipset generated from the same source file, with (very)
minimal ifdeffery.

The drivers check the SB DSP version to decide if they are being loaded
for the right chip. AZT1605 returns 2.1 by default and AZT2316 3.1.
This isn't full-proof as the DSP version can actually be set through
software but it's close enough -- as far as I've been able to see, the
DSP version can not be stored in the EEPROM and the cards will therefore
startup with the defaults.

This distinction could (with the same success rate) also be used to
decide which chip we're looking at at runtime meaning a single, merged
driver is also an option but I feel it's actually nicer this way. A
merged driver would have to postpone translating the passed in resource
values to the card configuration until it knew which one it was looking
at and would need to postpone erring out on mpu_irq=10 for azt1605 and
mpu_irq=3 for azt2316.

The drivers have been tested on various cards. For snd-azt1605:

FCC-ID I38-MMSN811: Aztech Sound Galaxy Nova 16 Extra
FCC-ID I38-MMSN822: Aztech Sound Galaxy Pro 16 II

and for snd-azt2316:

FCC-ID I38-MMSN824: Aztech Sound Galaxy Pro 16 AB
FCC-ID I38-MMSN826: Trust Sound Expert DeLuxe Wave 32 (05201)
FCC-ID I38-MMSN830: Trust Sound Expert DeLuxe 16+ (05202)
FCC-ID I38-MMSN837: Packard Bell ISA Soundcard 030069
FCC-ID I38-MMSN846: Trust Sound Expert DeLuxe 16-3D (06300)
FCC-ID I38-MMSN847: Trust Sound Expert DeLuxe Wave 32-3D (06301)
FCC-ID I38-MMSN852: Aztech Sound Galaxy Waverider Pro 32-3D

826 and 846 were also marketed directly by Aztech and then known as:

FCC-ID I38-MMSN826: Aztech Sound Galaxy Waverider 32+
FCC-ID I38-MMSN846: Aztech Sound Galaxy Nova 16 Extra II-3D

Together, these cover the AZT1605 and AT2316A, AZT2316R and AZT2316-S
chipsets. All cards work fully -- full-duplex PCM, MIDI and FM. Full
duplex is a little flaky on some.

I38-MSN811 tends to not work in full-duplex but sometimes does with the
highest success rate being achieved when you first start the capture and
then a playback instead of the other way around (it's a CS4231-KL
codec).

The cards with an AD1845XP codec (my I38-MMSN826 and one of my
I38-MMSN830s) are also somewhat duplex-challenged. Sometimes full-duplex
works, sometimes not and this varies from try to try. This seems likely
to be a timing problem somewhere inside wss-lib.

I38-MMSN826 has an additional "ICS2115 WaveFront" wavetable synth
onboard that isn't supported yet. The wavetable synths on I38-MMSN847
and I38-MMSN852 are wired directly to the standard MPU-401 UART and the
AUX1 input on the codec and work without problem.

CD-ROM audio on the cards is routed to the codec "Line" input, Line-In
to its Aux input, and FM/Wavetable to its AUX1 input. I did not rename
the controls due to the capture source enumeration: I see that
capture-source overrides are hardcoded in wss-lib and this is just too
ugly to live.

Versus the old snd-sgalaxy driver these drivers add support for the
models without a configuration EEPROM (which are common), full-duplex,
MPU-401 UART and OPL3. In the future they might grow support for that
ICS2115 WaveFront synth on 826 and an hwdep interface to write to the
EEPROM on the models that have one.
Signed-off-by: NRene Herman <rene.herman@gmail.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
      49531192
  5. 04 8月, 2010 1 次提交
    • J
      Documentation: update broken web addresses. · 0ea6e611
      由 Justin P. Mattock 提交于 
      Below you will find an updated version from the original series bunching all patches into one big patch
updating broken web addresses that are located in Documentation/*
Some of the addresses date as far far back as 1995 etc... so searching became a bit difficult,
the best way to deal with these is to use web.archive.org to locate these addresses that are outdated.
Now there are also some addresses pointing to .spec files some are located, but some(after searching
on the companies site)where still no where to be found. In this case I just changed the address
to the company site this way the users can contact the company and they can locate them for the users.
Signed-off-by: NJustin P. Mattock <justinmattock@gmail.com>
Signed-off-by: NThomas Weber <weber@corscience.de>
Signed-off-by: NMike Frysinger <vapier.adi@gmail.com>
Cc: Paulo Marques <pmarques@grupopie.com>
Cc: Randy Dunlap <rdunlap@xenotime.net>
Cc: Michael Neuling <mikey@neuling.org>
Signed-off-by: NJiri Kosina <jkosina@suse.cz>
      0ea6e611
  7. 10 5月, 2010 1 次提交
    • K
      ALSA: Merge es1688 and es968 drivers · a20971b2
      由 Krzysztof Helt 提交于 
      The ESS ES968 chip is nothing more then a PnP companion
for a non-PnP audio chip. It was paired with non-PnP ESS' chips:
ES688 and ES1688. The ESS' audio chips are handled by the es1688
driver in native mode. The PnP cards are handled by the ES968
driver in SB compatible mode.

Move the ES968 chip handling to the es1688 driver so the driver
can handle both PnP and non-PnP cards. The es968 is removed.

Also, a new PnP id is added for the card I acquired (the change
was tested on this card).
Signed-off-by: NKrzysztof Helt <krzysztof.h1@wp.pl>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
      a20971b2
  9. 22 4月, 2010 1 次提交
  11. 02 3月, 2010 1 次提交
  13. 18 1月, 2010 1 次提交
  15. 14 1月, 2010 1 次提交
  17. 25 12月, 2009 1 次提交
  19. 15 12月, 2009 1 次提交
  21. 16 11月, 2009 1 次提交
  23. 02 11月, 2009 1 次提交
  25. 01 11月, 2009 1 次提交
    • S
      ALSA: snd-pcsp: add nopcm mode · bcc2c6b7
      由 Stas Sergeev 提交于 
      Currently, if the high-res timers are unavailable, snd-pcsp does not
initialize. People who choose it over pcspkr, loose their console beeps
in that case and get annoyed.
With this patch, the console beeps remain regardless of the high-res
timers. Additionally, the "nopcm" modparam is added to forcibly
disable the PCM capabilities of the driver.
Signed-off-by: NStas Sergeev <stsp@aknet.ru>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
      bcc2c6b7
  27. 06 10月, 2009 1 次提交
  29. 01 10月, 2009 1 次提交
  31. 07 9月, 2009 1 次提交
    • T
      ALSA: dummy - Fake buffer allocations · a68c4d11
      由 Takashi Iwai 提交于 
      Instead of allocating the real buffers, use a fake buffer and ignore
read/write in the dummy driver so that we can save the resources.
For mmap, a single page (unique to the direction, though) is reused
to all buffers.

When the app requires to read/write the real buffers, pass fake_buffer=0
module option at loading time.  This will get back to the old behavior.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
      a68c4d11
  33. 03 9月, 2009 1 次提交
  35. 27 8月, 2009 1 次提交
    • T
      ALSA: Add debug module option · 36ce99c1
      由 Takashi Iwai 提交于 
      Add debug module option to snd core.
This controls the debug print level.  When CONFIG_SND_DEBUG_VERBOSE
is set, you can suppress the debug messages by giving or changing this
parameter to a lower value.  debug=0 means no debug messsages.
As default, it's set to the verbose level 2.

Since this option can be changed dynamically via sysfs file, you can
suppress the verbose debug messages on the fly, which wasn't possible
before.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
      36ce99c1
  37. 24 6月, 2009 1 次提交
  39. 13 6月, 2009 1 次提交
  41. 25 5月, 2009 1 次提交
  43. 14 5月, 2009 1 次提交
    • W
      ALSA: SB X-Fi driver merge · 8cc72361
      由 Wai Yew CHAY 提交于 
      The Sound Blaster X-Fi driver supports Creative solutions based on
20K1 and 20K2 chipsets.

Supported hardware :

Creative Sound Blaster X-Fi Titanium Fatal1ty® Champion Series
Creative Sound Blaster X-Fi Titanium Fatal1ty Professional Series
Creative Sound Blaster X-Fi Titanium Professional Audio
Creative Sound Blaster X-Fi Titanium
Creative Sound Blaster X-Fi Elite Pro
Creative Sound Blaster X-Fi Platinum
Creative Sound Blaster X-Fi Fatal1ty
Creative Sound Blaster X-Fi XtremeGamer
Creative Sound Blaster X-Fi XtremeMusic

Current release features:

* ALSA PCM Playback
* ALSA Record
* ALSA Mixer

Note:

* External I/O modules detection not included.
Signed-off-by: NWai Yew CHAY <wychay@ctl.creative.com>
Singed-off-by: NRyan RICHARDS <ryan_richards@creativelabs.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
      8cc72361
  45. 06 5月, 2009 1 次提交
  47. 04 5月, 2009 1 次提交
  49. 14 4月, 2009 1 次提交
  51. 26 2月, 2009 1 次提交
  53. 17 2月, 2009 1 次提交
  55. 13 2月, 2009 1 次提交
  57. 31 1月, 2009 1 次提交
  59. 29 1月, 2009 1 次提交
  61. 28 1月, 2009 1 次提交
  63. 19 12月, 2008 3 次提交
  65. 18 12月, 2008 1 次提交
    • T
      ALSA: hda - Fix silent HP output on D975 · e28d8322
      由 Takashi Iwai 提交于 
      Some desktops seems to have no HP/mic jack detection on the front panel,
which results in the silent output in the recent driver, because the
driver mutes the output (to save power) when no plug is detected.

This patch adds a new model that disables the jack-detection.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
      e28d8322
  67. 09 12月, 2008 1 次提交
  69. 04 12月, 2008 1 次提交