1. 06 7月, 2011 1 次提交
  2. 08 3月, 2011 1 次提交
  3. 01 2月, 2011 2 次提交
    • G
      Revert "appletalk: move to staging" · 0ffbf8bf
      Greg Kroah-Hartman 提交于
      This reverts commit a6238f21
      
      Appletalk got some patches to fix up the BLK usage in it in the
      network tree, so this removal isn't needed.
      
      Cc: Arnd Bergmann <arnd@arndb.de>
      Cc: <acme@ghostprotocols.net>
      Cc: netdev@vger.kernel.org,
      Cc: David Miller <davem@davemloft.net>
      Signed-off-by: NGreg Kroah-Hartman <gregkh@suse.de>
      0ffbf8bf
    • A
      appletalk: move to staging · a6238f21
      Arnd Bergmann 提交于
      For all I know, Appletalk is dead, the only reasonable
      use right now would be nostalgia, and that can be served
      well enough by old kernels. The code is largely not
      in a bad shape, but it still uses the big kernel lock,
      and nobody seems motivated to change that.
      
      FWIW, the last release of MacOS that supported Appletalk
      was MacOS X 10.5, made in 2007, and it has been abandoned
      by Apple with 10.6. Using TCP/IP instead of Appletalk has
      been supported since MacOS 7.6, which was released in
      1997 and is able to run on most of the legacy hardware.
      Signed-off-by: NArnd Bergmann <arnd@arndb.de>
      Cc: Arnaldo Carvalho de Melo <acme@ghostprotocols.net>
      Cc: netdev@vger.kernel.org
      Signed-off-by: NGreg Kroah-Hartman <gregkh@suse.de>
      a6238f21
  4. 17 12月, 2010 1 次提交
  5. 21 10月, 2010 1 次提交
    • Y
      ceph: factor out libceph from Ceph file system · 3d14c5d2
      Yehuda Sadeh 提交于
      This factors out protocol and low-level storage parts of ceph into a
      separate libceph module living in net/ceph and include/linux/ceph.  This
      is mostly a matter of moving files around.  However, a few key pieces
      of the interface change as well:
      
       - ceph_client becomes ceph_fs_client and ceph_client, where the latter
         captures the mon and osd clients, and the fs_client gets the mds client
         and file system specific pieces.
       - Mount option parsing and debugfs setup is correspondingly broken into
         two pieces.
       - The mon client gets a generic handler callback for otherwise unknown
         messages (mds map, in this case).
       - The basic supported/required feature bits can be expanded (and are by
         ceph_fs_client).
      
      No functional change, aside from some subtle error handling cases that got
      cleaned up in the refactoring process.
      Signed-off-by: NSage Weil <sage@newdream.net>
      3d14c5d2
  6. 06 8月, 2010 1 次提交
    • W
      DNS: Separate out CIFS DNS Resolver code · 1a4240f4
      Wang Lei 提交于
      Separate out the DNS resolver key type from the CIFS filesystem into its own
      module so that it can be made available for general use, including the AFS
      filesystem module.
      
      This facility makes it possible for the kernel to upcall to userspace to have
      it issue DNS requests, package up the replies and present them to the kernel
      in a useful form.  The kernel is then able to cache the DNS replies as keys
      can be retained in keyrings.
      
      Resolver keys are of type "dns_resolver" and have a case-insensitive
      description that is of the form "[<type>:]<domain_name>".  The optional <type>
      indicates the particular DNS lookup and packaging that's required.  The
      <domain_name> is the query to be made.
      
      If <type> isn't given, a basic hostname to IP address lookup is made, and the
      result is stored in the key in the form of a printable string consisting of a
      comma-separated list of IPv4 and IPv6 addresses.
      
      This key type is supported by userspace helpers driven from /sbin/request-key
      and configured through /etc/request-key.conf.  The cifs.upcall utility is
      invoked for UNC path server name to IP address resolution.
      
      The CIFS functionality is encapsulated by the dns_resolve_unc_to_ip() function,
      which is used to resolve a UNC path to an IP address for CIFS filesystem.  This
      part remains in the CIFS module for now.
      
      See the added Documentation/networking/dns_resolver.txt for more information.
      Signed-off-by: NWang Lei <wang840925@gmail.com>
      Signed-off-by: NDavid Howells <dhowells@redhat.com>
      Acked-by: NJeff Layton <jlayton@redhat.com>
      Signed-off-by: NSteve French <sfrench@us.ibm.com>
      1a4240f4
  7. 30 6月, 2010 1 次提交
  8. 04 4月, 2010 2 次提交
  9. 31 3月, 2010 1 次提交
  10. 13 7月, 2009 1 次提交
  11. 09 6月, 2009 1 次提交
    • S
      net: add IEEE 802.15.4 socket family implementation · 9ec76716
      Sergey Lapin 提交于
      Add support for communication over IEEE 802.15.4 networks. This implementation
      is neither certified nor complete, but aims to that goal. This commit contains
      only the socket interface for communication over IEEE 802.15.4 networks.
      One can either send RAW datagrams or use SOCK_DGRAM to encapsulate data
      inside normal IEEE 802.15.4 packets.
      
      Configuration interface, drivers and software MAC 802.15.4 implementation will
      follow.
      
      Initial implementation was done by Maxim Gorbachyov, Maxim Osipov and Pavel
      Smolensky as a research project at Siemens AG. Later the stack was heavily
      reworked to better suit the linux networking model, and is now maitained
      as an open project partially sponsored by Siemens.
      Signed-off-by: NDmitry Eremin-Solenikov <dbaryshkov@gmail.com>
      Signed-off-by: NSergey Lapin <slapin@ossfans.org>
      Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      9ec76716
  12. 27 2月, 2009 1 次提交
  13. 08 1月, 2009 1 次提交
  14. 25 11月, 2008 1 次提交
  15. 22 11月, 2008 1 次提交
  16. 21 11月, 2008 1 次提交
  17. 09 10月, 2008 1 次提交
    • L
      net: Distributed Switch Architecture protocol support · 91da11f8
      Lennert Buytenhek 提交于
      Distributed Switch Architecture is a protocol for managing hardware
      switch chips.  It consists of a set of MII management registers and
      commands to configure the switch, and an ethernet header format to
      signal which of the ports of the switch a packet was received from
      or is intended to be sent to.
      
      The switches that this driver supports are typically embedded in
      access points and routers, and a typical setup with a DSA switch
      looks something like this:
      
      	+-----------+       +-----------+
      	|           | RGMII |           |
      	|           +-------+           +------ 1000baseT MDI ("WAN")
      	|           |       |  6-port   +------ 1000baseT MDI ("LAN1")
      	|    CPU    |       |  ethernet +------ 1000baseT MDI ("LAN2")
      	|           |MIImgmt|  switch   +------ 1000baseT MDI ("LAN3")
      	|           +-------+  w/5 PHYs +------ 1000baseT MDI ("LAN4")
      	|           |       |           |
      	+-----------+       +-----------+
      
      The switch driver presents each port on the switch as a separate
      network interface to Linux, polls the switch to maintain software
      link state of those ports, forwards MII management interface
      accesses to those network interfaces (e.g. as done by ethtool) to
      the switch, and exposes the switch's hardware statistics counters
      via the appropriate Linux kernel interfaces.
      
      This initial patch supports the MII management interface register
      layout of the Marvell 88E6123, 88E6161 and 88E6165 switch chips, and
      supports the "Ethertype DSA" packet tagging format.
      
      (There is no officially registered ethertype for the Ethertype DSA
      packet format, so we just grab a random one.  The ethertype to use
      is programmed into the switch, and the switch driver uses the value
      of ETH_P_EDSA for this, so this define can be changed at any time in
      the future if the one we chose is allocated to another protocol or
      if Ethertype DSA gets its own officially registered ethertype, and
      everything will continue to work.)
      Signed-off-by: NLennert Buytenhek <buytenh@marvell.com>
      Tested-by: NNicolas Pitre <nico@marvell.com>
      Tested-by: NByron Bradley <byron.bbradley@gmail.com>
      Tested-by: NTim Ellis <tim.ellis@mac.com>
      Tested-by: NPeter van Valderen <linux@ddcrew.com>
      Tested-by: NDirk Teurlings <dirk@upexia.nl>
      Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      91da11f8
  18. 23 9月, 2008 1 次提交
  19. 08 7月, 2008 1 次提交
    • P
      vlan: uninline __vlan_hwaccel_rx · 7750f403
      Patrick McHardy 提交于
      The function is huge and included at least once in every VLAN acceleration
      capable driver. Uninline it; to avoid having drivers depend on the VLAN
      module, the function is always built in statically when VLAN is enabled.
      
      With all VLAN acceleration capable drivers that build on x86_64 enabled,
      this results in:
      
         text    data     bss     dec     hex filename
      6515227  854044  343968 7713239  75b1d7 vmlinux.inlined
      6505637  854044  343968 7703649  758c61 vmlinux.uninlined
      ----------------------------------------------------------
        -9590
      Signed-off-by: NPatrick McHardy <kaber@trash.net>
      Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      7750f403
  20. 29 1月, 2008 1 次提交
  21. 15 7月, 2007 1 次提交
  22. 11 7月, 2007 1 次提交
  23. 07 5月, 2007 1 次提交
  24. 06 5月, 2007 1 次提交
  25. 27 4月, 2007 1 次提交
  26. 26 4月, 2007 1 次提交
  27. 09 2月, 2007 1 次提交
  28. 23 9月, 2006 1 次提交
    • P
      [NetLabel]: core NetLabel subsystem · d15c345f
      Paul Moore 提交于
      Add a new kernel subsystem, NetLabel, to provide explicit packet
      labeling services (CIPSO, RIPSO, etc.) to LSM developers.  NetLabel is
      designed to work in conjunction with a LSM to intercept and decode
      security labels on incoming network packets as well as ensure that
      outgoing network packets are labeled according to the security
      mechanism employed by the LSM.  The NetLabel subsystem is configured
      through a Generic NETLINK interface described in the header files
      included in this patch.
      Signed-off-by: NPaul Moore <paul.moore@hp.com>
      Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      d15c345f
  29. 13 1月, 2006 1 次提交
  30. 15 11月, 2005 1 次提交
  31. 30 8月, 2005 2 次提交
  32. 13 5月, 2005 1 次提交
    • J
      [NET] ieee80211 subsystem · b453872c
      Jeff Garzik 提交于
      Contributors:
      Host AP contributors
      James Ketrenos <jketreno@linux.intel.com>
      Francois Romieu <romieu@fr.zoreil.com>
      Adrian Bunk <bunk@stusta.de>
      Matthew Galgoci <mgalgoci@parcelfarce.linux.th
      eplanet.co.uk>
      b453872c
  33. 17 4月, 2005 1 次提交
    • L
      Linux-2.6.12-rc2 · 1da177e4
      Linus Torvalds 提交于
      Initial git repository build. I'm not bothering with the full history,
      even though we have it. We can create a separate "historical" git
      archive of that later if we want to, and in the meantime it's about
      3.2GB when imported into git - space that would just make the early
      git days unnecessarily complicated, when we don't have a lot of good
      infrastructure for it.
      
      Let it rip!
      1da177e4