- 25 3月, 2010 1 次提交
-
-
由 Adrian Hunter 提交于
In the extended CSD register the CARD_TYPE is an 8-bit value of which the upper 6 bits were reserved in JEDEC specifications prior to version 4.4. In version 4.4 two of the reserved bits were designated for identifying support for the newly added High-Speed Dual Data Rate. Unfortunately the mmc_read_ext_csd() function required that the reserved bits be zero instead of ignoring them as it should. This patch makes mmc_read_ext_csd() ignore the CARD_TYPE bits that are reserved or not yet supported. It also stops the function jumping to the end as though an error occurred, when it is only warns that the CARD_TYPE bits (that it does interpret) are invalid. Signed-off-by: NAdrian Hunter <adrian.hunter@nokia.com> Cc: <linux-mmc@vger.kernel.org> Signed-off-by: NAndrew Morton <akpm@linux-foundation.org> Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
-
- 23 9月, 2009 2 次提交
-
-
由 Adrian Hunter 提交于
According to the standard, the SWITCH command should be followed by a SEND_STATUS command to check for errors. Signed-off-by: NAdrian Hunter <adrian.hunter@nokia.com> Acked-by: NMatt Fleming <matt@console-pimps.org> Cc: Ian Molton <ian@mnementh.co.uk> Cc: "Roberto A. Foglietta" <roberto.foglietta@gmail.com> Cc: Jarkko Lavinen <jarkko.lavinen@nokia.com> Cc: Denis Karpov <ext-denis.2.karpov@nokia.com> Cc: Pierre Ossman <pierre@ossman.eu> Cc: Philip Langdale <philipl@overt.org> Cc: "Madhusudhan" <madhu.cr@ti.com> Cc: <linux-mmc@vger.kernel.org> Signed-off-by: NAndrew Morton <akpm@linux-foundation.org> Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
-
由 Jarkko Lavinen 提交于
Add support for the new MMC command SLEEP_AWAKE. Signed-off-by: NJarkko Lavinen <jarkko.lavinen@nokia.com> Signed-off-by: NAdrian Hunter <adrian.hunter@nokia.com> Acked-by: NMatt Fleming <matt@console-pimps.org> Cc: Ian Molton <ian@mnementh.co.uk> Cc: "Roberto A. Foglietta" <roberto.foglietta@gmail.com> Cc: Jarkko Lavinen <jarkko.lavinen@nokia.com> Cc: Denis Karpov <ext-denis.2.karpov@nokia.com> Cc: Pierre Ossman <pierre@ossman.eu> Cc: Philip Langdale <philipl@overt.org> Cc: "Madhusudhan" <madhu.cr@ti.com> Cc: <linux-mmc@vger.kernel.org> Signed-off-by: NAndrew Morton <akpm@linux-foundation.org> Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
-
- 15 7月, 2008 1 次提交
-
-
由 Adrian Bunk 提交于
This patch removes a CVS tag that wasn't updated for a long time. Signed-off-by: NAdrian Bunk <bunk@kernel.org> Signed-off-by: NPierre Ossman <drzeus@drzeus.cx>
-
- 24 9月, 2007 1 次提交
-
-
由 David Brownell 提交于
Teach the MMC/SD/SDIO system headers that some hosts use SPI mode - New host capabilities and status bits * MMC_CAP_SPI, with mmc_host_is_spi() test * mmc_host.use_spi_crc flag - SPI-specific declarations: * Response types, MMC_RSP_SPI_R* * Two SPI-only commands * Status bits used native to SPI: R1_SPI_*, R2_SPI_* - Fix a few (unrelated) whitespace bugs in the headers. - Reorder a few mmc_host fields, removing several bytes of padding None of these changes affect current code. Signed-off-by: NDavid Brownell <dbrownell@users.sourceforge.net> Signed-off-by: NPierre Ossman <drzeus@drzeus.cx>
-
- 23 9月, 2007 1 次提交
-
-
由 Pierre Ossman 提交于
Make sure we do not try to parse a structure we do not understand. Signed-off-by: NPierre Ossman <drzeus@drzeus.cx>
-
- 01 5月, 2007 3 次提交
-
-
由 Pierre Ossman 提交于
Move protocol operations and definitions into their own files in an effort to separate protocol handling and bus arbitration more clearly. Signed-off-by: NPierre Ossman <drzeus@drzeus.cx>
-
由 Pierre Ossman 提交于
All host drivers were #include:ing mmc/protocol.h just to get access to the OCR bit defines. Move these to host.h instead. Signed-off-by: NPierre Ossman <drzeus@drzeus.cx>
-
由 Pierre Ossman 提交于
Support for MMC 4.2 sector based cards. This tweaks the init a bit and reads a new field out of the EXT_CSD. Signed-off-by: NPierre Ossman <drzeus@drzeus.cx>
-
- 05 2月, 2007 1 次提交
-
-
由 Philip Langdale 提交于
Thanks to the generous donation of an SDHC card by John Gilmore, and the surprisingly enlightened decision by the SD Card Association to publish useful specs, I've been able to bash out support for SDHC. The changes are not too profound: i) Add a card flag indicating the card uses block level addressing and check it in the block driver. As we never took advantage of byte-level addressing, this simply involves skipping the block -> byte translation when sending commands. ii) The layout of the CSD is changed - a set of fields are discarded to make space for a larger C_SIZE. We did not reference any of the discarded fields except those related to the C_SIZE. iii) Read and write timeouts are fixed values and not calculated from CSD values. iv) Before invoking SEND_APP_OP_COND, we must invoke the new SEND_IF_COND to inform the card we support SDHC. Signed-off-by: NPhilipl Langdale <philipl@overt.org> Signed-off-by: NPierre Ossman <drzeus@drzeus.cx>
-
- 02 12月, 2006 3 次提交
-
-
由 Pierre Ossman 提交于
Modern SD cards support a clock speed of 50 MHz. Make sure we test for this capability and do the song and dance required to activate it. Activating high speed support actually modifies the TRAN_SPEED field of the CSD. But as the spec says that the cards must report 50 MHz, we might as well skip re-reading the CSD. Signed-off-by: NPierre Ossman <drzeus@drzeus.cx>
-
由 Philip Langdale 提交于
This change adds support for the mmc4 4-bit wide-bus mode. The mmc4 spec defines 8-bit and 4-bit transfer modes. As we do not support any 8-bit hardware, this patch only adds support for the 4-bit mode, but it can easily be built upon when the time comes. The 4-bit mode is electrically compatible with SD's 4-bit mode but the procedure for turning it on is different. This patch implements only the essential parts of the procedure as defined by the spec. Two additional steps are recommended but not compulsory. I am documenting them here so that there's a record. 1) A bus-test mechanism is implemented using dedicated mmc commands which allow for testing the functionality of the data bus at the electrical level. This is pretty paranoid and they way the commands work is not compatible with the mmc subsystem (they don't set valid CRC values). 2) MMC v4 cards can indicate they would like to draw more than the default amount of current in wide-bus modes. We currently will never switch the card into a higher draw mode. Supposedly, allowing the card to draw more current will let it perform better, but the specs seem to indicate that the card will function correctly without the mode change. Empirical testing supports this interpretation. Signed-off-by: NPhilip Langdale <philipl@overt.org> Signed-off-by: NPierre Ossman <drzeus@drzeus.cx>
-
由 Philip Langdale 提交于
This adds support for the high-speed modes defined by mmc v4 (assuming the host controller is up to it). On a TI sdhci controller, it improves read speed from 1.3MBps to 2.3MBps. The TI controller can only go up to 24MHz, but everything helps. Another person has taken this basic patch and used it on a Nokia 770 to get a bigger boost because that controller can run at 48MHZ. Signed-off-by: NPhilip Langdale <philipl@overt.org> Signed-off-by: NPierre Ossman <drzeus@drzeus.cx>
-
- 06 10月, 2006 1 次提交
-
-
由 Pierre Ossman 提交于
SD cards extend the protocol by allowing the host to query a card how many blocks were successfully stored on the medium. This allows us to safely write chunks of blocks at once. Signed-off-by: NPierre Ossman <drzeus@drzeus.cx> Cc: Russell King <rmk@arm.linux.org.uk> Signed-off-by: NAndrew Morton <akpm@osdl.org> Signed-off-by: NLinus Torvalds <torvalds@osdl.org>
-
- 02 2月, 2006 1 次提交
-
-
由 Russell King 提交于
Some hosts need to know the command type, so pass it via a set of flags in cmd->flags. Signed-off-by: NRussell King <rmk+kernel@arm.linux.org.uk>
-
- 29 11月, 2005 1 次提交
-
-
由 Pierre Ossman 提交于
A review against MMC/SD specifications found some errors in the current implementation. Signed-off-by: NPierre Ossman <drzeus@drzeus.cx> Signed-off-by: NRussell King <rmk+kernel@arm.linux.org.uk>
-
- 08 9月, 2005 1 次提交
-
-
由 Pierre Ossman 提交于
Infrastructure for 4-bit bus transfers with SD cards. Signed-off-by: NPierre Ossman <drzeus@drzeus.cx> Cc: Russell King <rmk@arm.linux.org.uk> Cc: David Brownell <david-b@pacbell.net> Signed-off-by: NAndrew Morton <akpm@osdl.org> Signed-off-by: NLinus Torvalds <torvalds@osdl.org>
-
- 21 5月, 2005 1 次提交
-
-
由 Pierre Ossman 提交于
Defines for the different command classes as defined in the MMC and SD specifications. Removes the check for high command classes and instead checks that the command classes needed are present. Previous solution killed forward compatibility at no apparent gain. Signed-of-by: Pierre Ossman
-
- 17 4月, 2005 1 次提交
-
-
由 Linus Torvalds 提交于
Initial git repository build. I'm not bothering with the full history, even though we have it. We can create a separate "historical" git archive of that later if we want to, and in the meantime it's about 3.2GB when imported into git - space that would just make the early git days unnecessarily complicated, when we don't have a lot of good infrastructure for it. Let it rip!
-