Add check for access to port-write (PW) message source device before
processing the PW message.  If source RIO device is not available (power
down or RIO link failure) trace back to a last available switch/port on
the PW message route and service failure at that point.
Signed-off-by: NAlexandre Bounine <alexandre.bounine@idt.com>
Cc: Thomas Moll <thomas.moll@sysgo.com>
Cc: Matt Porter <mporter@kernel.crashing.org>
Cc: Li Yang <leoli@freescale.com>
Cc: Kumar Gala <galak@kernel.crashing.org>
Cc: Micha Nelissen <micha@neli.hopto.org>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>

Modify the way how RapidIO switch operations are declared.  Multiple
assignments through the linker script replaced by single initialization
call.
Signed-off-by: NAlexandre Bounine <alexandre.bounine@idt.com>
Cc: Matt Porter <mporter@kernel.crashing.org>
Cc: Li Yang <leoli@freescale.com>
Cc: Kumar Gala <galak@kernel.crashing.org>
Cc: Thomas Moll <thomas.moll@sysgo.com>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>

Add RapidIO Port-Write message handling in the context of Error
   Management Extensions Specification Rev.1.3.
Signed-off-by: NAlexandre Bounine <alexandre.bounine@idt.com>
Tested-by: NThomas Moll <thomas.moll@sysgo.com>
Cc: Matt Porter <mporter@kernel.crashing.org>
Cc: Li Yang <leoli@freescale.com>
Cc: Kumar Gala <galak@kernel.crashing.org>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>

Extentions to RapidIO switch support:

1. modify switch route operation declarations to allow using single
   switch-specific file for family of switches that share the same route
   table operations.

2. add standard route table operations for switches that that support
   route table manipulation registers as defined in the Rev.1.3 of RapidIO
   specification.

3. add clear-route-table operation for switches

4. add CPSxx and TSIxxx families of RapidIO switches
Signed-off-by: NAlexandre Bounine <alexandre.bounine@idt.com>
Tested-by: NThomas Moll <thomas.moll@sysgo.com>
Cc: Matt Porter <mporter@kernel.crashing.org>
Cc: Li Yang <leoli@freescale.com>
Cc: Kumar Gala <galak@kernel.crashing.org>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>

The RapidIO system size will auto probe in RIO setup.  The route table
and rionet_active in rionet.c are changed to be allocated dynamically
according to the size of the system.
Signed-off-by: NZhang Wei <wei.zhang@freescale.com>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NPaul Mackerras <paulus@samba.org>

Remove the deprecated __attribute_used__.

[Introduce __section in a few places to silence checkpatch /sam]
Signed-off-by: NAdrian Bunk <bunk@kernel.org>
Signed-off-by: NSam Ravnborg <sam@ravnborg.org>

Addresses issues raised with the 2.6.12-rc6-mm1 RIO support.  Fix dma_mask
init, shrink some code, general cleanup.
Signed-off-by: NMatt Porter <mporter@kernel.crashing.org>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Adds a RapidIO subsystem to the kernel.  RIO is a switched fabric interconnect
used in higher-end embedded applications.  The curious can look at the specs
over at http://www.rapidio.org

The core code implements enumeration/discovery, management of
devices/resources, and interfaces for RIO drivers.

There's a lot more to do to take advantages of all the hardware features.
However, this should provide a good base for folks with RIO hardware to start
contributing.
Signed-off-by: NMatt Porter <mporter@kernel.crashing.org>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>