1. 30 3月, 2016 1 次提交
    • A
      iwlwifi: mvm: add LQM vendor command and notification · 03098268
      Aviya Erenfeld 提交于
      LQM stands for Link Quality Measurement. The firmware
      will collect a defined set of statitics (see the
      notification for details) that allow to know how busy
      the medium is. The driver issues a request to the firmware
      that includes the duration of the measurement (the firmware
      needs to be on channel for that amount of time) and the
      timeout (in case the firmware has a lot of offchannel
      activities). If the timeout elapses, the firmware will
      send partial results which are still valuable.
      In case of disassociation / channel switch and alike, the
      driver is in charge of stopping the measurements and the
      firmware will reply with partial results.
      
      The user space API for now is debugfs only and will be
      implmemented in an upcoming patch.
      Signed-off-by: NAviya Erenfeld <aviya.erenfeld@intel.com>
      Signed-off-by: NEmmanuel Grumbach <emmanuel.grumbach@intel.com>
      03098268
  2. 20 3月, 2016 1 次提交
  3. 10 3月, 2016 1 次提交
  4. 07 3月, 2016 1 次提交
  5. 02 3月, 2016 4 次提交
  6. 28 2月, 2016 9 次提交
  7. 24 2月, 2016 1 次提交
  8. 01 2月, 2016 4 次提交
  9. 21 12月, 2015 4 次提交
  10. 20 12月, 2015 2 次提交
  11. 16 12月, 2015 1 次提交
    • S
      iwlwifi: mvm: change protocol offload flows · c97dab40
      Sara Sharon 提交于
      RFC4862 states that "In all cases, a node MUST NOT respond to
      a Neighbor Solicitation for a tentative address".
      Currently the driver configures the NS offload and does not wait
      for address to become permanent, thus violating the RFC.
      Just removing the address from the address list is not good enough
      for all cases, since the NS messages are needed for the duplicate
      address detection and should not be discarded.
      
      For d0i3 disable NS offload. Put tentative address in the address
      list so the NS packet will not be filtered out by ucode.
      For D3 the platform will not wake from NS packets - so enable
      NS offload while removing the tentative address from the list.
      
      Given that now NS offload might be disabled, and that the ucode
      uses the IP data for other puroposes (L3 filtering) add two
      independent flags indicating if IPv4\IPv6 data is valid.
      Signed-off-by: NSara Sharon <sara.sharon@intel.com>
      Signed-off-by: NEmmanuel Grumbach <emmanuel.grumbach@intel.com>
      c97dab40
  12. 13 12月, 2015 3 次提交
  13. 07 12月, 2015 1 次提交
  14. 02 12月, 2015 3 次提交
  15. 26 11月, 2015 4 次提交