Skip to content

K
Kernel

openeuler / Kernel
1 年多 前同步成功

通知 8
Star 0
Fork 0
K
Kernel
切换分支/标签
  1. 27 2月, 2010 1 次提交
  3. 24 2月, 2010 2 次提交
  5. 23 2月, 2010 3 次提交
    • B
      IPv6: better document max_addresses parameter · e79dc484
      由 Brian Haley 提交于 
      Andrew Morton wrote:
>> >From ip-sysctl.txt file in kernel documentation I can see following description
>> for max_addresses:
>> max_addresses - INTEGER
>>         Number of maximum addresses per interface.  0 disables limitation.
>>         It is recommended not set too large value (or 0) because it would
>>         be too easy way to crash kernel to allow to create too much of
>>         autoconfigured addresses.
           ^^^^^^^^^^^^^^

>> If this parameter applies only for auto-configured IP addressed, please state
>> it more clearly in docs or rename the parameter to show that it refers to
>> auto-configuration.

It did mention autoconfigured in the text, but the below makes it more obvious.

More clearly document IPv6 max_addresses parameter.
Signed-off-by: NBrian Haley <brian.haley@hp.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      e79dc484
    • R
      PCI PM: Make it possible to force using INTx for PCIe PME signaling · c39fae14
      由 Rafael J. Wysocki 提交于 
      Apparently, some machines may have problems with PCI run-time power
management if MSIs are used for the native PCIe PME signaling.  In
particular, on the MSI Wind U-100 PCIe PME interrupts are not
generated by a PCIe root port after a resume from suspend to RAM, if
the system wake-up was triggered by a PME from the device attached to
this port.  [It doesn't help to free the interrupt on suspend and
request it back on resume, even if that is done along with disabling
the MSI and re-enabling it, respectively.]  However, if INTx
interrupts are used for this purpose on the same machine, everything
works just fine.

For this reason, add a kernel command line switch allowing one to
request that MSIs be not used for the native PCIe PME signaling,
introduce a DMI table allowing us to blacklist machines that need
this switch to be set by default and put the MSI Wind U-100 into this
table.
Signed-off-by: NRafael J. Wysocki <rjw@sisk.pl>
Signed-off-by: NJesse Barnes <jbarnes@virtuousgeek.org>
      c39fae14
    • R
      PCI PM: PCIe PME root port service driver · c7f48656
      由 Rafael J. Wysocki 提交于 
      PCIe native PME detection mechanism is based on interrupts generated
by root ports or event collectors every time a PCIe device sends a
PME message upstream.

Once a PME message has been sent by an endpoint device and received
by its root port (or event collector in the case of root complex
integrated endpoints), the Requester ID from the message header is
registered in the root port's Root Status register.  At the same
time, the PME Status bit of the Root Status register is set to
indicate that there's a PME to handle.  If PCIe PME interrupt is
enabled for the root port, it generates an interrupt once the PME
Status has been set.  After receiving the interrupt, the kernel can
identify the PCIe device that generated the PME using the Requester
ID from the root port's Root Status register. [For details, see PCI
Express Base Specification, Rev. 2.0.]

Implement a driver for the PCIe PME root port service working in
accordance with the above description.

Based on a patch from Shaohua Li <shaohua.li@intel.com>.
Signed-off-by: NRafael J. Wysocki <rjw@sisk.pl>
Signed-off-by: NJesse Barnes <jbarnes@virtuousgeek.org>
      c7f48656
  7. 21 2月, 2010 1 次提交
    • R
      ARM: allow alignment fault mode to be configured at kernel boot · d944d549
      由 Russell King 提交于 
      Some glibc versions intentionally create lots of alignment faults in
their gconv code, which if not fixed up, results in segfaults during
boot.  This can prevent systems booting properly.

There is no clear hard-configurable default for this; the desired
default depends on the nature of the userspace which is going to be
booted.

So, provide a way for the alignment fault handler to be configured via
the kernel command line.
Signed-off-by: NRussell King <rmk+kernel@arm.linux.org.uk>
      d944d549
  9. 07 2月, 2010 1 次提交
  11. 03 2月, 2010 1 次提交
  13. 29 1月, 2010 1 次提交
  15. 27 1月, 2010 2 次提交
  17. 23 1月, 2010 1 次提交
  19. 17 1月, 2010 1 次提交
  21. 13 1月, 2010 1 次提交
  23. 12 1月, 2010 6 次提交
  25. 11 1月, 2010 1 次提交
  27. 03 1月, 2010 3 次提交
  29. 02 1月, 2010 1 次提交
  31. 31 12月, 2009 1 次提交
  33. 27 12月, 2009 3 次提交
  35. 25 12月, 2009 1 次提交
  37. 24 12月, 2009 4 次提交
  39. 23 12月, 2009 3 次提交
  41. 22 12月, 2009 1 次提交
  43. 20 12月, 2009 1 次提交