This resolves the differences between the original 8250 patch, the revised 8250 patch
and the independant clean up of the octeon driver (to use platform devices properly yay!)
Signed-off-by: NAlan Cox <alan@linux.intel.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>

The old interface just copies bits over and calls the newer one.
In addition we can now pass more information.
Signed-off-by: NAlan Cox <alan@linux.intel.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>

The drivers/tty/serial dir is already getting rather busy.
Relocate the 8250 related drivers to their own subdir to
reduce the clutter.

Note that sunsu.c is not included in this move -- it is
8250-like hardware, but it does not use any of the existing
infrastructure -- and does not depend on SERIAL_8250.
Signed-off-by: NPaul Gortmaker <paul.gortmaker@windriver.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@suse.de>

This patch converts the drivers in drivers/tty/serial/* to use the
module_platform_driver() macro which makes the code smaller and a bit
simpler.

Cc: Arnd Bergmann <arnd@arndb.de>
Cc: Jamie Iles <jamie@jamieiles.com>
Cc: Yoichi Yuasa <yuasa@linux-mips.org>
Signed-off-by: NAxel Lin <axel.lin@gmail.com>
Acked-by: NAlan Cox <alan@linux.intel.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@suse.de>

The Synopsys DesignWare 8250 is an 8250 that has an extra interrupt that
gets raised when writing to the LCR when busy.  To handle this we need
special serial_out, serial_in and handle_irq methods.  Add a new
platform driver that uses these accessors.

Cc: Alan Cox <alan@linux.intel.com>
Cc: Arnd Bergmann <arnd@arndb.de>
Signed-off-by: NJamie Iles <jamie@jamieiles.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@suse.de>

This reverts commit 6b1a98d1.

It causes a build error that needs to be resolved differently.

Cc: Alan Cox <alan@linux.intel.com>
Cc: Arnd Bergmann <arnd@arndb.de>
Cc: Jamie Iles <jamie@jamieiles.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@suse.de>

The Synopsys DesignWare 8250 is an 8250 that has an extra interrupt that
gets raised when writing to the LCR when busy.  To handle this we need
special serial_out, serial_in and handle_irq methods.  Add a new
function serial8250_use_designware_io() that configures a uart_port with
these accessors.

Cc: Alan Cox <alan@linux.intel.com>
Acked-by: NArnd Bergmann <arnd@arndb.de>
Signed-off-by: NJamie Iles <jamie@jamieiles.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@suse.de>