Add support for PCM1796 chips that are connected with an I2C bus instead
of SPI.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>

Introduce some trivial functions to better document the relationships of
the various model callbacks.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>

Add functions to allow model drivers to communicate with external chips
by doing I/O with the not-used-for-MIDI UART.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>

To enable the MIDI port, model drivers must now set flags in
device_config, not only in misc_flags.  This allows model drivers to
enable the UART without creating an ALSA MIDI device.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>

Rename the pcm_dev_cfg field to device_config because there will be
additional flags that do not describe PCM devices.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>

Factor out the common code of the mixer callbacks that handle controls
that just switch a single GPIO bit.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>

The Xonar D2X and DX are very similar to the D2 and D1, respectively, so
we can handle the differences dynamically instead of using a separate
model structure for each one.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>

Handle the differences between the X-Meridian and the other models in
the probe callback instead of using a second model structure.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>

Introduce symbols that indicate the two models handled by the snd-oxygen
driver, instead of using a magic number.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>

Add a probe callback to the model structure so that model-specific
drivers can refine their model detection before the card is initialized.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>

Put a copy of the model structure into the chip structure so that model-
specific drivers can modify it depending on a particular device
instance.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>

When setting the SPDIF channel status sample rate field, use the
recently defined symbols instead of magic numbers.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>

Signed-off-by: NJaroslav Kysela <perex@perex.cz>

The VT1702 and VT1708S have a second S/PDIF output which is used to
connect to a HDMI transmitter.  This patch adds support for it.
Signed-off-by: NHarald Welte <HaraldWelte@viatech.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
Signed-off-by: NJaroslav Kysela <perex@perex.cz>

This mode allows an output stream to have two substreams, one for the
speakers and one for the headphone.  Each of the substreams has independent
PCM data and uses a different DAC.
Signed-off-by: NHarald Welte <HaraldWelte@viatech.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
Signed-off-by: NJaroslav Kysela <perex@perex.cz>

Signed-off-by: NHarald Welte <HaraldWelte@viatech.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
Signed-off-by: NJaroslav Kysela <perex@perex.cz>

The VT1702 and VT1708S codecs are new HDA codecs by VIA.

This patch adds support for them to the patch_via.c file for HDA
Signed-off-by: NHarald Welte <HaraldWelte@viatech.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
Signed-off-by: NJaroslav Kysela <perex@perex.cz>

In the current driver, there is a consistent mistake between the SURROUND and
the SIDE channels.  This patch fixes it.
Signed-off-by: NHarald Welte <HaraldWelte@viatech.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
Signed-off-by: NJaroslav Kysela <perex@perex.cz>

Signed-off-by: NHarald Welte <HaraldWelte@viatech.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
Signed-off-by: NJaroslav Kysela <perex@perex.cz>

* add extra parenthesis to make code more readable
* use kzalloc() for alloc+zero rather than kcalloc()
* ensure that AUTO_SEQ_* starts at 0
Signed-off-by: NHarald Welte <HaraldWelte@viatech.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
Signed-off-by: NJaroslav Kysela <perex@perex.cz>

Don't use __init but __devinit to define probe function.  A pointer to
sa11xx_uda1341_probe is passed to the core via platform_driver_register
and so the function must not disappear after the module is loaded.  Using
__init and having HOTPLUG=y and SND_SA11XX_UDA1341=m the following
probably oopses:

	echo -n sa11xx_uda1341.1 > /sys/bus/platform/driver/sa11xx_uda1341/unbind
	echo -n sa11xx_uda1341.1 > /sys/bus/platform/driver/sa11xx_uda1341/bind
Signed-off-by: NUwe Kleine-König <ukleinek@informatik.uni-freiburg.de>
Cc: Russell King <rmk+kernel@arm.linux.org.uk>
Cc: Brian Avery <b.avery@hp.com>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
Signed-off-by: NJaroslav Kysela <perex@perex.cz>

Signed-off-by: NMatthew Ranostay <mranostay@embeddedalley.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
Signed-off-by: NJaroslav Kysela <perex@perex.cz>

Changed the mux naming scheme from "IEC9258 Mux" to "IEC958 Playback Source" to match
the coding style.

Signed-by-off: Matthew Ranostay <mranostay@embeddedalley.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
Signed-off-by: NJaroslav Kysela <perex@perex.cz>

Added slave_dig_outs entries for several IDT codecs that have multiple
SPDIF outs, and enabled these SPDIF outs in several pin configs.
Signed-off-by: NMatthew Ranostay <mranostay@embeddedalley.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
Signed-off-by: NJaroslav Kysela <perex@perex.cz>

Muting the DAC masks artefacts introduced as the digital stream shuts
down, for example when the input stops being clocked.
Signed-off-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
Signed-off-by: NJaroslav Kysela <perex@perex.cz>

Hopefully this will make merges a little bit easier.
Signed-off-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
Signed-off-by: NJaroslav Kysela <perex@perex.cz>

Signed-off-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
Signed-off-by: NJaroslav Kysela <perex@perex.cz>

Added support for playing a stream on multiple digital outs. This is done
by defining codec->slave_dig_outs as array of hda_nid_t with a null-terminated entry to set the
slave SPDIF outs, in which the slave outs have cloned settings of the master out (e.g. dig_out_nid).
Signed-off-by: NMatthew Ranostay <mranostay@embeddedalley.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
Signed-off-by: NJaroslav Kysela <perex@perex.cz>

The __exit cleanup_oss_soundcore() is called from
the __init init_soundcore(). This causes section mismatch
and breaks kernel's linking on sparc64.

Remove the __exit attribute from the cleanup_oss_soundcore().
Signed-off-by: NKrzysztof Helt <krzysztof.h1@wp.pl>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
Signed-off-by: NJaroslav Kysela <perex@perex.cz>

The lock used in snd_ctl_dev_disconnect() should be card->ctl_files_rwlock
for protection of card->ctl_files entries, instead of card->controls_rwsem.
Reported-by: NVegard Nossum <vegard.nossum@gmail.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
Signed-off-by: NJaroslav Kysela <perex@perex.cz>

before:
total: 113 errors, 169 warnings, 2786 lines checked
total: 26 errors, 24 warnings, 504 lines checked

after:
total: 14 errors, 163 warnings, 2799 lines checked
total: 0 errors, 24 warnings, 504 lines checked

Compile tested only.
Signed-off-by: NAlexander Beregalov <a.beregalov@gmail.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
Signed-off-by: NJaroslav Kysela <perex@perex.cz>

before:
total: 96 errors, 66 warnings, 2612 lines checked

after:
total: 11 errors, 64 warnings, 2624 lines checked

Compile tested only.
Signed-off-by: NAlexander Beregalov <a.beregalov@gmail.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
Signed-off-by: NJaroslav Kysela <perex@perex.cz>

Inspired by Alexander Beregalov's patches for wtm and aureon.c,
I decided to run checkpatch on some more files. After some work
checkpatch.pl-0.23 --no-tree --file --strict <file> reports
0 errors, 0 warnings, 0 checks, n lines checked for:
phase.c
phase.h
juli.c (1 check about unused code, maybe we should comment it)
juli.h (no changes necessary)
In other files I have just fixed // comments and long lines along the
way (but not all of them), more coming up.
Signed-off-by: NVedran Miletic <rivanvx@gmail.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
Signed-off-by: NJaroslav Kysela <perex@perex.cz>

Removed unneeded hp_nid references for 92hd73xx codec family.
Signed-off-by: NMatthew Ranostay <mranostay@embeddedalley.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
Signed-off-by: NJaroslav Kysela <perex@perex.cz>

Dynamically create mux controls for SPDIF outs on certain IDT/Sigmatel codecs.
Signed-off-by: NMatthew Ranostay <mranostay@embeddedalley.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
Signed-off-by: NJaroslav Kysela <perex@perex.cz>

before:
total: 2 errors, 0 warnings, 20 lines checked
total: 49 errors, 2 warnings, 518 lines checked

after:
total: 0 errors, 0 warnings, 20 lines checked
total: 0 errors, 0 warnings, 518 lines checked

Compile tested, size and code are equal.
Signed-off-by: NAlexander Beregalov <a.beregalov@gmail.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
Signed-off-by: NJaroslav Kysela <perex@perex.cz>

before:
total: 304 errors, 137 warnings, 2259 lines checked

after:
total: 0 errors, 121 warnings, 2284 lines checked

Compile tested, size is different because of include was changed,
but without that change md5sum is different because of cmp cx,dx/cmp
dx,cx swap and __LINE__ was changed in printk function.
Signed-off-by: NAlexander Beregalov <a.beregalov@gmail.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
Signed-off-by: NJaroslav Kysela <perex@perex.cz>

Signed-off-by: NCliff Cai <cliff.cai@analog.com>
Signed-off-by: NBryan Wu <cooloney@kernel.org>
Signed-off-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
Signed-off-by: NJaroslav Kysela <perex@perex.cz>

Signed-off-by: NCliff Cai <cliff.cai@analog.com>
Signed-off-by: NBryan Wu <cooloney@kernel.org>
Signed-off-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
Signed-off-by: NJaroslav Kysela <perex@perex.cz>

Signed-off-by: NCliff Cai <cliff.cai@analog.com>
Signed-off-by: NBryan Wu <cooloney@kernel.org>
Signed-off-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
Signed-off-by: NJaroslav Kysela <perex@perex.cz>