- 03 11月, 2005 1 次提交
-
-
由 Mirco Macrelli 提交于
Signed-off-by: NAndrew Morton <akpm@osdl.org> Signed-off-by: NDmitry Torokhov <dtor@mail.ru>
-
- 01 11月, 2005 1 次提交
-
-
由 Arthur Othieno 提交于
CONFIG_PC is left-over cruft after the introduction of CONFIG_X86_PC with the subarch split. Remove it, and fixup the remaining users to depend on CONFIG_X86_PC instead. Signed-off-by: NArthur Othieno <a.othieno@bluewin.ch> Signed-off-by: NLinus Torvalds <torvalds@osdl.org>
-
- 29 10月, 2005 1 次提交
-
-
由 Dmitry Torokhov 提交于
Input: convert drivers/input/mouse to dynamic input_dev allocation This is required for input_dev sysfs integration Signed-off-by: NDmitry Torokhov <dtor@mail.ru> Signed-off-by: NGreg Kroah-Hartman <gregkh@suse.de>
-
- 22 10月, 2005 1 次提交
-
-
由 Matthew Wilcox 提交于
Update drivers to new input layer changes. Signed-off-by: NHelge Deller <deller@parisc-linux.org> Signed-off-by: NMatthew Wilcox <willy@parisc-linux.org> Reorder code in gscps2_interrupt() and only enable ports when opened. This fixes issues with hangs booting an SMP kernel on my C360. Previously serio_interrupt() could be called before the lock in struct serio was initialised. Signed-off-by: NRichard Hirst <rhirst@parisc-linux.org> Signed-off-by: NKyle McMartin <kyle@parisc-linux.org>
-
- 08 9月, 2005 1 次提交
-
-
由 Pekka Enberg 提交于
This patch converts kcalloc(1, ...) calls to use the new kzalloc() function. Signed-off-by: NPekka Enberg <penberg@cs.helsinki.fi> Cc: Vojtech Pavlik <vojtech@suse.cz> Signed-off-by: NAndrew Morton <akpm@osdl.org> Signed-off-by: NLinus Torvalds <torvalds@osdl.org>
-
- 04 9月, 2005 3 次提交
-
-
由 Vojtech Pavlik 提交于
Signed-off-by: NVojtech Pavlik <vojtech@suse.cz> Signed-off-by: NDmitry Torokhov <dtor@mail.ru>
-
由 Vojtech Pavlik 提交于
Signed-off-by: NVojtech Pavlik <vojtech@suse.cz> Signed-off-by: NDmitry Torokhov <dtor@mail.ru>
-
由 Dmitry Torokhov 提交于
Rearrange attribute code to use generic show and set handlers instead of replicating them for every attribute; switch to using attribute_group instead of creating all attributes manually. All this saves about 4K. Signed-off-by: NDmitry Torokhov <dtor@mail.ru>
-
- 08 8月, 2005 1 次提交
-
-
由 Stephen Evanchik 提交于
Signed-off-by: NDmitry Torokhov <dtor@mail.ru>
-
- 24 7月, 2005 1 次提交
-
-
由 Sergey Vlasov 提交于
Synaptics driver used child->type to select either 3-byte or 4-byte packet size for the pass-through port; this gives wrong results for the newer protocols. Change the check to use child->pktsize instead. Signed-off-by: NSergey Vlasov <vsu@altlinux.ru> Signed-off-by: NDmitry Torokhov <dtor@mail.ru>
-
- 15 7月, 2005 1 次提交
-
-
由 Vojtech Pavlik 提交于
There are wheel mice that respond to Logitech probes and report that they have only 2 buttons (such as e-Aser mouse) and this stops the wheel from being used as a middle button. Change the driver to always report BTN_MIDDLE capability if a wheel is present. Also, never reset BTN_RIGHT capability in logips2pp code - there are no Logitech mice that have only one button and if some other mice happen to respond to Logitech's query we could do the wrong thing. Signed-off-by: NVojtech Pavlik <vojtech@suse.cz> Signed-off-by: NDmitry Torokhov <dtor@mail.ru>
-
- 11 7月, 2005 3 次提交
-
-
由 Peter Osterlund 提交于
The condition in alps_init() was also inverted and the driver was enabling tapping mode only if it was already enabled. Signed-off-by: NPeter Osterlund <petero2@telia.com> Signed-off-by: NVojtech Pavlik <vojtech@suse.cz> Signed-off-by: NDmitry Torokhov <dtor@mail.ru>
-
由 David Moore 提交于
The driver would not reset pass-through mode when performing resume of a DualPoint touchpad causing it to stop working until next reboot. Signed-off-by: NVojtech Pavlik <vojtech@suse.cz> Signed-off-by: NDmitry Torokhov <dtor@mail.ru>
-
由 Simon Horman 提交于
Toshiba Dynabooks require the same workaround as Satellites - Synaptics report rate should be lowered to 40pps (from 80), otherwise KBC starts losing keypresses. Signed-off-by: NSimon Horman <horms@valinux.co.jp> Signed-off-by: NVojtech Pavlik <vojtech@suse.cz> Signed-off-by: NDmitry Torokhov <dtor@mail.ru>
-
- 21 6月, 2005 1 次提交
-
-
由 Yani Ioannou 提交于
[PATCH] Driver Core: drivers/i2c/chips/w83781d.c - drivers/s390/block/dcssblk.c: update device attribute callbacks Signed-off-by: NYani Ioannou <yani.ioannou@gmail.com> Signed-off-by: NGreg Kroah-Hartman <gregkh@suse.de>
-
- 17 6月, 2005 1 次提交
-
-
由 Dmitry Torokhov 提交于
It looks like logic for enabling hardware tapping in ALPS driver was inverted and we enable it only if it was already enabled by BIOS or firmware. I have a confirmation from one user that the patch below fixes the problem for him and it might be beneficial if we could get it into 2.6.12. Signed-off-by: NDmitry Torokhov <dtor@mail.ru> Signed-off-by: NAndrew Morton <akpm@osdl.org> Signed-off-by: NLinus Torvalds <torvalds@osdl.org>
-
- 01 6月, 2005 4 次提交
-
-
由 Dmitry Torokhov 提交于
to allow easy switching at run-time. Signed-off-by: NDmitry Torokhov <dtor@mail.ru>
-
由 Dmitry Torokhov 提交于
given number of bytes from device. Change ps2_command to allow using 0 as command ID and actually pass it to the device instead of working as a drain. Signed-off-by: NDmitry Torokhov <dtor@mail.ru>
-
由 Dmitry Torokhov 提交于
operations do not iterfere with each other. Also make sure that serio core takes serio->drv_sem not only for connect/disconnect but for reconnect too. Signed-off-by: NDmitry Torokhov <dtor@mail.ru>
-
由 Ivan Casado Ruiz 提交于
I have an Ahtec laptop with a ALPS GlidePoint device, with 4 buttons. With Linux hernel 2.6.12rc4 and rc5 I'm unable to use the vertical scroll buttons (BACK and FORWARD). BACK gets detected as BTN_MIDDLE and FORWARD is undetected. I've modified the drivers/input/mouse/alps.c from 2.6.12rc5 and now it works fine! Signed-off-by: NVojtech Pavlik <vojtech@suse.cz> Signed-off-by: NDmitry Torokhov <dtor@mail.ru>
-
- 29 5月, 2005 6 次提交
-
-
由 Dmitry Torokhov 提交于
compared to "classic" PS/2 mice, provide appropriate resolution setting handler. Signed-off-by: NDmitry Torokhov <dtor@mail.ru>
-
由 Dmitry Torokhov 提交于
the rest of protocols in preparation to dynamic protocol switching. Signed-off-by: NDmitry Torokhov <dtor@mail.ru>
-
由 Dmitry Torokhov 提交于
- do not try to set rate and resolution in init method, let psmouse core do it for us. This also removes special quirks from the core; - do not disable mouse before doing full reset - meaningless; - some formatting and whitespace cleanups. Signed-off-by: NDmitry Torokhov <dtor@mail.ru>
-
由 Kenan Esau 提交于
From: Kenan Esau <kenan.esau@conan.de> Signed-off-by: NVojtech Pavlik <vojtech@suse.cz> Signed-off-by: NDmitry Torokhov <dtor@mail.ru>
-
由 Dmitry Torokhov 提交于
core takes care of calling open and close methods only when needed. Signed-off-by: NDmitry Torokhov <dtor@mail.ru>
-
由 Dmitry Torokhov 提交于
Signed-off-by: NDmitry Torokhov <dtor@mail.ru>
-
- 28 5月, 2005 3 次提交
-
-
由 Dmitry Torokhov 提交于
is no reason one driver should take 10 lines in dmesg. Signed-off-by: NDmitry Torokhov <dtor@mail.ru>
-
由 Vojtech Pavlik 提交于
sends an incorrect ID and wasn't recognized. Reported-by: NStefan Seyfried <seife@suse.de> Signed-off-by: NVojtech Pavlik <vojtech@suse.cz> Signed-off-by: NDmitry Torokhov <dtor@mail.ru>
-
由 Andrew Morton 提交于
Signed-off-by: NAndrew Morton <akpm@osdl.org> Signed-off-by: NVojtech Pavlik <vojtech@suse.cz> Signed-off-by: NDmitry Torokhov <dtor@mail.ru>
-
- 17 5月, 2005 2 次提交
-
-
由 Dmitry Torokhov 提交于
ALPS needs to be reset for detection to work reliably when reconnecting. Signed-off-by: NDmitry Torokhov <dtor@mail.ru> Cc: Vojtech Pavlik <vojtech@suse.cz> Signed-off-by: NAndrew Morton <akpm@osdl.org> Signed-off-by: NLinus Torvalds <torvalds@osdl.org>
-
由 Andrew Morton 提交于
Make the alps printk output look consistent. Cc: Vojtech Pavlik <vojtech@suse.cz> Signed-off-by: NAndrew Morton <akpm@osdl.org> Signed-off-by: NLinus Torvalds <torvalds@osdl.org>
-
- 17 4月, 2005 1 次提交
-
-
由 Linus Torvalds 提交于
Initial git repository build. I'm not bothering with the full history, even though we have it. We can create a separate "historical" git archive of that later if we want to, and in the meantime it's about 3.2GB when imported into git - space that would just make the early git days unnecessarily complicated, when we don't have a lot of good infrastructure for it. Let it rip!
-