Added a quirk (model=m51va) for Packard Bell RS65 with ALC663.

Reference: Novell bnc#496787
	https://bugzilla.novell.com/show_bug.cgi?id=496787Signed-off-by: NTakashi Iwai <tiwai@suse.de>

The NID and ASS numbers were swapped...
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Added a couple of debug prints to show the checked id numbers in
alc_subsystem_id().
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

- Support ASUS F81Se F5Q P80 U20A U80 U50 UX50 for ALC269
- Support ASUS F70SL UX20 X58LE F50Z N80Vc N81Te N505Tp Vx3V N5051A
  for ALC663
- Support DELL ZM1 for ALC272
Signed-off-by: NKailang Yang <kailang@realtek.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Don't unmute unneeded amps for input mixers of ALC662 & co.
It caused possible recording noises.
Signed-off-by: NKailang Yang <kailang@realtek.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Added the models for quirk bitmask 1734:110x and 1734:113x of
Fujitsu laptops.

This will fix the model detection for Amilo Xa3540.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

ALC889 has two SPDIF outputs: 0x06, 0x10. Board vendors can use either or both.
DX58SO uses 0x10, but the driver assumes 0x06. The safe solution is to add
0x10 as slave output to the existing 0x06.
Reported-by: NJeroen Van Breedam <jeroen.vanbreedam@sgr5.be>
Tested-by: NJeroen Van Breedam <jeroen.vanbreedam@sgr5.be>
Signed-off-by: NWu Fengguang <fengguang.wu@intel.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Add a quirk model=acer-aspire for Acer Ferrari 5000 with ALC883 codec.
Note that model=auto doesn't work for this laptop because of broken BIOS
(that doesn't set the subsystem id properly).
Tested-by: NRuss Dill <russ.dill@gmail.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

In patch_realtek.c, don't create empty or single-item "Input Source"
control elements that are simply superfluous.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

The check for the amp-output must be done for widget-caps rather than
pin-caps as implemented in the recent change...  Simply a thinko.

Also, add the similar checks to all places that put output-amp mutes
in the initialization.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Added snd_hda_query_pin_caps() to read and cache pin-cap values
to avoid too frequently issuing the same verbs.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Don't set amp-out values to pins without PINCAP_OUT capability,
which are usually assigned for digital mics on ALC663/ALC272.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Fix the detection of digital-mic inputs on ALC663 / ALC272 codecs
in the auto-detection mode.  The automatic mic switch via plugging
isn't implemented yet, though.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

The previous commit breaks the (digital-) beep on ALC662.
ALC662 has the connection index 0x05 while ALC662 and ALC272 have the
index 0x04 for the beep widget.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

ALC662/663 codecs have Beep Amplifier Index 0x04 not 0x05 in 0x0b NID.
Confirmed by testing on real hardware.
Signed-off-by: NJaroslav Kysela <perex@perex.cz>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Noises can be heard on analog outputs of (some model of) Lenovo
Ideapad due to the hardware problem, and the only workaround right now
is to fix the sample rate to 44.1kHz.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Fixed the wrong bits check to identify ALC888S-VC model in
alc888_coef_init().
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Added model=3stack-hp for HP Educ.ar desktop machine (103c:2a72).
Signed-off-by: NHerton Ronaldo Krzesinski <herton@mandriva.com.br>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Mute speaker outputs on headphone insertion for machines that use
3stack-hp model.
Signed-off-by: NHerton Ronaldo Krzesinski <herton@mandriva.com.br>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Add additional 4 channel mode for 3stack-hp models.
Signed-off-by: NHerton Ronaldo Krzesinski <herton@mandriva.com.br>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

The recent update enabled the model=sony-assamd for all ALC262 with
PCI SSID 104d:90xx.  But this includes the VAIO VGN-AR* that has the
primary codec of STAC92xx and the secondary ALC262 as a slave
digital-only codec.  For this device, the model=auto must be chosen
to work properly.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

When an ALC268 codec is set up as the digital-only (as found in Toshiba
laptops), it shouldn't contain any beep control that conflict with the
primary codec.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Forgot to remove an unused variable.
  sound/pci/hda/patch_realtek.c: In function ‘alc882_auto_init_analog_input’:
  sound/pci/hda/patch_realtek.c:7018: warning: unused variable ‘vref’
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Use SND_PCI_QUIRK_MASK() to match all devices with 103c:17xx for
HP BPC model.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Added model=hp-bpc for new HP xw series (103c:170b).
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Clean up the input-pin setup in automatic mode in patch_realtek.c.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Clean up / fix quirk entries for Sony laptops with ALC262 codec
using NSD_PCI_QUIRK_MASK().

This also fixes the kernel bug #12780
	http://bugme.linux-foundation.org/show_bug.cgi?id=12780Signed-off-by: NTakashi Iwai <tiwai@suse.de>

The Acer Aspire 6530G needs the 4930G "model" for the front mic to
work properly.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Reference: Ubuntu bug #33245
    https://bugs.launchpad.net/bugs/332456Signed-off-by: NLuke Yelavich <themuso@ubuntu.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Signed-off-by: NMichael Schwingen <michael@schwingen.org>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Now it's done in the common code.
Also use the common access functions for pin defaults.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

ALC268 can be configured as digital-only, e.g. for HDMI, on some
machines.  Allow the parser to set up the digital-only mode.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Remove the doubly attachment in patch_alc268().
The input beep is attached conditionally only when needed.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

When ALC262 codec is configured as digital-only, it's meaningless to
add the digital beep input.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Acer X3200 needs model=auto, otherwise model=acer is pre-selected.

Reference: Novell bnc#476268
	https://bugzilla.novell.com/show_bug.cgi?id=476268Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Added the support of multiple digital outputs via auto-probing for
Realtek ALC88x codecs.  The multiple outputs are handled as slave
streams, so only one PCM stream (and the corresponding IEC958*
elements) is provided to control both digital outputs.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

The recent patch_realtek.c contains the slave digital-out support
as well.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Force model=auto for Acer AX1700-U3700A with ALC888 codec.
Since Acer devices are handlded as model=acer as default, the auto
parsing has to be specified explicitly.
(Maybe it's better rather to remove this default model=acer handling,
 though.)
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Detect multiple digital-out pins in snd_hda_parse_pin_defconfig().
The dig_out_pin and dig_out_type fields become arrays.

The codec parser still doesn't use this multiple pins detection, though.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Added a quirk for Asus Z37E for fixing suspend/hibernation problem.

Reference:
	https://bugs.edge.launchpad.net/ubuntu/+source/linux/+bug/25896
	http://launchpadlibrarian.net/17053575/0001-Add-quirk-for-ASUS-Z37E-to-make-sound-audible-afte.patch
	https://bugtrack.alsa-project.org/alsa-bug/bug_view_page.php?bug_id=4282Signed-off-by: NTakashi Iwai <tiwai@suse.de>