1. 10 6月, 2009 2 次提交
    • K
      [SCSI] mpt fusion: rewrite of all internal generated functions · 37c60f37
      Kashyap, Desai 提交于
      Rewrite of all internal generated functions that issue commands to firmware,
      porting them to be single threaded using the generic MPT_MGMT
      struct. Implemented using completion Queue.
      Signed-off-by: NKashyap Desai <kadesai@lsi.com>
      Signed-off-by: NJames Bottomley <James.Bottomley@HansenPartnership.com>
      37c60f37
    • K
      [SCSI] mpt fusion: Fixing 1078 data corruption issue for 36GB memory region · 14d0f0b0
      Kashyap, Desai 提交于
      The reason for this change is there is a data corruption when four different
      physical memory regions in the 36GB to 37GB region are
      accessed. This is only affecting 1078.
      
      The solution is we need to use different addressing when filling in
      the scatter gather table for the effected memory regions.  So instead
      of snooping on all four different memory holes, we treat any physical
      addresses in the 36GB address with the same algorithm.
      
      The fix is explained below
      1) Ensure that the message frames are NOT located in the trouble
      region. There is no remapping available for message frames, they must
      be allocated outside the problem region.
      2) Ensure that Sense buffers are NOT in the trouble region. There is
      no remapping available.
      3) Walk through the SGE entries and if any are inside the trouble region
         then they need to be remapped as discussed below.
      	1) Set the Local Address bit in the SGE Flags field.
        	MPI_SGE_FLAGS_LOCAL_ADDRESS
        	2) Ensure we are using 64-bit SGEs
        	3) Set MSb (Bit 63) of the 64-bit address, this will indicate buffer
      	location is Host Memory.
      Signed-off-by: NKashyap Desai <kadesai@lsi.com>
      Signed-off-by: NJames Bottomley <James.Bottomley@HansenPartnership.com>
      14d0f0b0
  2. 12 7月, 2008 1 次提交
  3. 08 7月, 2008 1 次提交
  4. 05 6月, 2008 1 次提交
  5. 13 10月, 2007 10 次提交
  6. 28 7月, 2007 1 次提交
  7. 19 7月, 2007 2 次提交
  8. 18 6月, 2007 2 次提交
  9. 06 6月, 2007 1 次提交
  10. 30 4月, 2007 1 次提交
    • E
      [SCSI] fusion: fix domain validation loops · 72978245
      Eric Moore 提交于
      After host reset, the device are programmed to default asyn narrow nego.
      We need to reprogram the parameter back to previous values.  If the host
      reset is called as a result of spi_dv_device() commands timing out, its
      possible to get into an infinite loop of dv to host reset.  This will
      prevent that case, as we merely program old values.  If host reset is
      called outside context of domain validation, then we can  call
      spi_dv_device.
      Signed-off-by: NEric Moore <Eric.Moore@lsi.com>
      Signed-off-by: NJames Bottomley <James.Bottomley@SteelEye.com>
      72978245
  11. 01 4月, 2007 1 次提交
  12. 20 3月, 2007 1 次提交
  13. 15 2月, 2007 1 次提交
    • T
      [PATCH] remove many unneeded #includes of sched.h · cd354f1a
      Tim Schmielau 提交于
      After Al Viro (finally) succeeded in removing the sched.h #include in module.h
      recently, it makes sense again to remove other superfluous sched.h includes.
      There are quite a lot of files which include it but don't actually need
      anything defined in there.  Presumably these includes were once needed for
      macros that used to live in sched.h, but moved to other header files in the
      course of cleaning it up.
      
      To ease the pain, this time I did not fiddle with any header files and only
      removed #includes from .c-files, which tend to cause less trouble.
      
      Compile tested against 2.6.20-rc2 and 2.6.20-rc2-mm2 (with offsets) on alpha,
      arm, i386, ia64, mips, powerpc, and x86_64 with allnoconfig, defconfig,
      allmodconfig, and allyesconfig as well as a few randconfigs on x86_64 and all
      configs in arch/arm/configs on arm.  I also checked that no new warnings were
      introduced by the patch (actually, some warnings are removed that were emitted
      by unnecessarily included header files).
      Signed-off-by: NTim Schmielau <tim@physik3.uni-rostock.de>
      Acked-by: NRussell King <rmk+kernel@arm.linux.org.uk>
      Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
      Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
      cd354f1a
  14. 03 2月, 2007 5 次提交
  15. 06 1月, 2007 1 次提交
  16. 08 12月, 2006 1 次提交
  17. 22 11月, 2006 1 次提交
  18. 13 7月, 2006 1 次提交
  19. 29 6月, 2006 1 次提交
  20. 10 6月, 2006 1 次提交
  21. 04 5月, 2006 1 次提交
  22. 15 3月, 2006 2 次提交
  23. 01 3月, 2006 1 次提交
    • J
      [SCSI] mptspi: Add transport class Domain Validation · c92f222e
      James Bottomley 提交于
      This is the first half of a patch to add the generic domain validation
      to mptspi.  It also creates a secondary "virtual" channel for raid
      component devices since these are now exported with no_uld_attach.
      
      What Eric and I would have really liked is to export all physical
      components on channel 0 and all raid components on channel 1.
      Unfortunately, this would result in device renumbering on platforms with
      mixed RAID/Physical devices which was considered unacceptable for
      userland stability reasons.
      
      Still to be done is to plug back the extra parameter setting and DV
      pieces on reset and hotplug.
      Signed-off-by: NJames Bottomley <James.Bottomley@SteelEye.com>
      c92f222e