Remove the old IUCV code from drivers/s390/net
Remove approprirate IUCV entries from drivers/s390/net/Makefile,
drivers/s390/net/Kconfig and arch/s390/defconfig
Signed-off-by: NFrank Pavlic <fpavlic@de.ibm.com>
Signed-off-by: NMartin Schwidefsky <schwidefsky@de.ibm.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

[PATCH 3/9] s390: Makefile cleanup

From: Frank Pavlic <fpavlic@de.ibm.com>
 	remove CONFIG_MPC from Makefile which was
	introduced accidently in the past.
Signed-off-by: NFrank Pavlic <fpavlic@de.ibm.com>
Signed-off-by: NJeff Garzik <jeff@garzik.org>

Hi jeff,
after the first shot I sent to you did not apply I
resend  two new patches I've made today to remove tty from ctc network driver.
Please apply ....

Thank you ...

Frank

From: Peter Tiedemann <ptiedem@de.ibm.com>
        [1/2]:
        tty support code will be removed from the ctc network device driver.
        Today we have a couple of alternatives which are performing much
        better. The second thing is that ctc should be a network
        device driver only.
        We should not mix tty and networking here.
        This first patch will remove the tty code from ctcmain.c .
        It also removes the build entry from the Makefile as well as TTY
        definitions from ctcmain.h.
        The second patch will remove two files, ctctty.c and ctctty.h.
Signed-off-by: NFrank Pavlic <fpavlic@de.ibm.com>
Signed-off-by: NJeff Garzik <jeff@garzik.org>

[patch 10/10] s390: qeth bug fixes.

From: Frank Pavlic <pavlic@de.ibm.com>

qeth network driver related changes:
 - due to OSA hardware changes in TCP Segmentation Offload
   support we are able now to pack TSO packets too.
   This fits perfectly in design of qeth buffer handling and
   sending data respectively.
 - remove skb_realloc_headroom from the sending path since
   hard_header_len value provides enough headroom now.
 - device recovery behaviour improvement
 - bug fixed in Enhanced Device Driver Packing functionality
Signed-off-by: NFrank Pavlic <pavlic@de.ibm.com>

[patch 1/10] s390: claw driver wiring.

From: Andy Richter <richtera@us.ibm.com>

claw network driver changes:
 - Add an entry to the drivers/s390/net Makefile to build the claw driver.
 - Add claw channel type to cu3088.
Signed-off-by: NFrank Pavlic <pavlic@de.ibm.com>

Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.

Let it rip!