This patch implements SDIO IRQ support for mfds which
announce the TMIO_MMC_SDIO_IRQ flag for tmio_mmc.
If MMC_CAP_SDIO_IRQ is also set SDIO IRQ signalling is activated.
Tested with a b43-based wireless SDIO card and sh_mobile_sdhi.
Signed-off-by: NArnd Hannemann <arnd@arndnet.de>
Signed-off-by: NChris Ball <cjb@laptop.org>

with "mmc: tmio: implement a bounce buffer for unaligned DMA"
gcc generates the following warnings:

drivers/mmc/host/tmio_mmc.c:654:6: warning: 'ret' may be used uninitialized in this function
drivers/mmc/host/tmio_mmc.c:730:6: warning: 'ret' may be used uninitialized in this function

This patch fixes these by setting ret to -EINVAL in the affected code paths.
Signed-off-by: NArnd Hannemann <arnd@arndnet.de>
Signed-off-by: NChris Ball <cjb@laptop.org>

For example, with SDIO WLAN cards, some transfers happen with buffers at
odd addresses, whereas the SH-Mobile DMA engine requires even addresses
for SDHI. This patch extends the tmio driver with a bounce buffer, that
is used for single entry scatter-gather lists both for sending and
receiving. If we ever encounter unaligned transfers with multi-element
sg lists, this patch will have to be extended. For now it just falls
back to PIO in this and other unsupported cases.
Signed-off-by: NGuennadi Liakhovetski <g.liakhovetski@gmx.de>
Acked-by: NSamuel Ortiz <sameo@linux.intel.com>
Signed-off-by: NChris Ball <cjb@laptop.org>

drivers/mmc/host/tmio_mmc.h is only used by drivers/mmc/host/tmio_mmc.c,
this needlessly complicates source-code handling.
Signed-off-by: NGuennadi Liakhovetski <g.liakhovetski@gmx.de>
Signed-off-by: NChris Ball <cjb@laptop.org>

The easiest way to fall back to PIO, when a DMA descriptor allocation
fails is to disable DMA on the controller but continue with the current
request in PIO mode. This way tmio_mmc_start_dma() can become void, since
it cannot be failing any more. The current version is also broken: it is
testing a wrong pointer and thus failing to recognise, that a descriptor
allocation wasn't successful.
Signed-off-by: NGuennadi Liakhovetski <g.liakhovetski@gmx.de>
Signed-off-by: NChris Ball <cjb@laptop.org>

The driver is capable of handling multi-element sg lists in both PIO and
DMA modes. In DMA mode this also allows to use the DMA sg capability more
efficiently and almost doubles the throughput.
Signed-off-by: NGuennadi Liakhovetski <g.liakhovetski@gmx.de>
Signed-off-by: NChris Ball <cjb@laptop.org>

Adjust the tmio_mmc block size check to accept 2-byte requests in 4-bit
mode if the hardware supports it.

Tested with the SDHI hardware block included in sh7724.
Signed-off-by: NYusuke Goda <yusuke.goda.sx@renesas.com>
Signed-off-by: NMatt Fleming <matt@console-pimps.org>
Acked-by: NMagnus Damm <damm@opensource.se>
Tested-by: NArnd Hannemann <arnd@arndnet.de>
Signed-off-by: NSamuel Ortiz <sameo@linux.intel.com>

Some controllers, supported by the tmio_mmc driver do not have the card
detect pin of a slot connected, so that polling needs to be used and
card detection is handled by other means.
This patch exposes a get_cd hook for that purpose.
Signed-off-by: NArnd Hannemann <arnd@arndnet.de>
Signed-off-by: NSamuel Ortiz <sameo@linux.intel.com>

kunmap_atomic() takes the cookie, returned by the kmap_atomic() as its
argument and not the page address, used as an argument to kmap_atomic().
This patch fixes the compile error:

In file included from drivers/mmc/host/tmio_mmc.c:37:
drivers/mmc/host/tmio_mmc.h: In function 'tmio_mmc_kunmap_atomic':
drivers/mmc/host/tmio_mmc.h:192: error: negative width in bit-field '<anonymous>'
Signed-off-by: NGuennadi Liakhovetski <g.liakhovetski@gmx.de>
Acked-by: NEric Miao <eric.y.miao@gmail.com>
Tested-by: NMagnus Damm <damm@opensource.se>
Cc: <stable@kernel.org>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>

Even though many mmc host drivers pass a pm_message_t argument to
mmc_suspend_host() that argument isn't used the by MMC core.  As host
drivers are converted to dev_pm_ops they'll have to construct
pm_message_t's (as they won't be passed by the PM subsystem any more) just
to appease the mmc suspend interface.

We might as well just delete the unused paramter.
Signed-off-by: NMatt Fleming <matt@console-pimps.org>
Acked-by: NAnton Vorontsov <cbouatmailru@gmail.com>
Acked-by: Michal Miroslaw <mirq-linux@rere.qmqm.pl>ZZ
Acked-by: NSascha Sommer <saschasommer@freenet.de>
Cc: <linux-mmc@vger.kernel.org>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>

Signed-off-by: NGuennadi Liakhovetski <g.liakhovetski@gmx.de>
Acked-by: NIan Molton <ian@mnementh.co.uk>
Signed-off-by: NPaul Mundt <lethal@linux-sh.org>

Write-protection status is not always available, e.g., micro-SD cards do not
have a write-protection switch at all. This patch adds a flag to let platforms
force tmio_mmc to consider the card writable.
Signed-off-by: NGuennadi Liakhovetski <g.liakhovetski@gmx.de>
Acked-by: NIan Molton <ian@mnementh.co.uk>
Signed-off-by: NPaul Mundt <lethal@linux-sh.org>

SDHI controllers on SuperH, served by the tmio_mmc driver, can use slave DMA
for data transfer. This patch adds support for the dmaengine API to the
tmio_mmc driver.
Signed-off-by: NGuennadi Liakhovetski <g.liakhovetski@gmx.de>
Acked-by: NIan Molton <ian@mnementh.co.uk>
Signed-off-by: NPaul Mundt <lethal@linux-sh.org>

This patch adds cell->disable() calls to the tmio-mmc
probe() error handling and the remove() function.
Signed-off-by: NMagnus Damm <damm@opensource.se>
Signed-off-by: NSamuel Ortiz <sameo@linux.intel.com>

This patch changes the tmio_mmc driver to wait 100ms
before checking the card detect status. This type of
delay is quite common among mmc drivers, it seems that
most hardware platforms need to give the hardware some
time to settle before checking card availabilty.

Hotplug is half-broken without this patch on the sh7724
Ecovec board. Hot insertion seems ok but eject is never
detected without this patch.
Signed-off-by: NMagnus Damm <damm@opensource.se>
Signed-off-by: NSamuel Ortiz <sameo@linux.intel.com>

Enable MMC_CAP_XX support in the tmio_mmc driver if
pdata->capabilities is set.
Signed-off-by: NYusuke Goda <goda.yusuke@renesas.com>
Signed-off-by: NMagnus Damm <damm@opensource.se>
Signed-off-by: NSamuel Ortiz <sameo@linux.intel.com>

This patch abstracts out the CNF area code from tmio_mmc which
is not present in all hardware that can use this driver. This
is required so that we can support non-toshiba based hardware.

ASIC3 support by Philipp Zabel
Signed-off-by: NIan Molton <ian@mnementh.co.uk>
Signed-off-by: NMagnus Damm <damm@opensource.se>
Signed-off-by: NSamuel Ortiz <sameo@linux.intel.com>

Improve the /proc/interrupts output so the irq number can be mapped to
platform device on boards with multiple tmio_mmc instances.
Signed-off-by: NMagnus Damm <damm@opensource.se>
Cc: <linux-mmc@vger.kernel.org>
Cc: Paul Mundt <lethal@linux-sh.org>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>

Now tmio_mmc is able to drive the MMC/SD cell in ASIC3.
Signed-off-by: NPhilipp Zabel <philipp.zabel@gmail.com>
Acked-by: NIan Molton <spyro@f2s.com>
Signed-off-by: NPierre Ossman <pierre@ossman.eu>

This patch fixes the clock setup in tmio_mmc.

  * Incorrect divider setting
  * Cruft written to the clock registers (seemingly harmless but Not
Good (tm))

It also eliminates some unnecessary ifs and tidies the loop syntax.

Thanks to Philipp Zabel who discovered the divider issue, commenting

   "Except for the SDCLK = HCLK (divider bypassed) case, the clock
    setting resulted in double the requested frequency.
    The smallest possible frequency (f_max/512) is configured with
    a divider setting 0x80, not 0x40."
Signed-off-by: NIan Molton <ian@mnementh.co.uk>
Signed-off-by: NPierre Ossman <pierre@ossman.eu>

ASIC3 can disable the memory, so we need to wait for mfd_cell->enable
to enable the memory before we can map the SD control registers.
Signed-off-by: NPhilipp Zabel <philipp.zabel@gmail.com>
Acked-by: NIan Molton <ian@mnementh.co.uk>
Signed-off-by: NPierre Ossman <pierre@ossman.eu>

Signed-off-by: NPhilipp Zabel <philipp.zabel@gmail.com>
Acked-by: NIan Molton <ian@mnementh.co.uk>
Signed-off-by: NPierre Ossman <pierre@ossman.eu>

Use an IRQF_TRIGGER_ flag in request_irq instead.
Signed-off-by: NPhilipp Zabel <philipp.zabel@gmail.com>
Acked-by: NIan Molton <ian@mnementh.co.uk>
Signed-off-by: NPierre Ossman <pierre@ossman.eu>

Some ASIC3 devices in the wild are connected with the address bus shifted
by one line, so that its 16-bit registers appear 32-bit aligned in host
memory space.
Signed-off-by: NPhilipp Zabel <philipp.zabel@gmail.com>
Acked-by: NIan Molton <ian@mnementh.co.uk>
Signed-off-by: NPierre Ossman <pierre@ossman.eu>

The Toshiba parts all have a 24 MHz HCLK, but HTC ASIC3 has a 24.576 MHz HCLK
and AMD Imageon w228x's HCLK is 80 MHz. With this patch, the MFD driver
provides the HCLK frequency to tmio_mmc via mfd_cell->driver_data.
Signed-off-by: NPhilipp Zabel <philipp.zabel@gmail.com>
Acked-by: NIan Molton <ian@mnementh.co.uk>
Acked-by: NSamuel Ortiz <sameo@openedhand.com>
Signed-off-by: NPierre Ossman <pierre@ossman.eu>

Update the tmio_mmc code to call mmc_free_host() when
done using the private data. Without this fix the driver
frees memory and then keeps on using it as private data.
Signed-off-by: NMagnus Damm <damm@opensource.se>
Acked-by: NIan Molton <ian@mnementh.co.uk>
Signed-off-by: NPierre Ossman <drzeus@drzeus.cx>

Update the tmio_mmc code to use resource_size(). With this
patch applied the correct resource size is passed to ioremap().
Signed-off-by: NMagnus Damm <damm@opensource.se>
Acked-by: NIan Molton <ian@mnementh.co.uk>
Signed-off-by: NPierre Ossman <drzeus@drzeus.cx>

In each case, if the NULL test is necessary, then the dereference should be
moved below the NULL test.

The semantic patch that makes this change is as follows:
(http://www.emn.fr/x-info/coccinelle/)

// <smpl>
@@
type T;
expression E;
identifier i,fld;
statement S;
@@

- T i = E->fld;
+ T i;
  ... when != E
      when != i
  if (E == NULL) S
+ i = E->fld;
// </smpl>
Signed-off-by: NJulia Lawall <julia@diku.dk>
Signed-off-by: NPierre Ossman <drzeus@drzeus.cx>

This patch adds support for the MMC subdevice 'cell' commonly found in
TMIO based MFDs.
Signed-off-by: NIan Molton <spyro@f2s.com>
Acked-by: NPierre Ossman <drzeus@drzeus.cx>
Signed-off-by: NSamuel Ortiz <sameo@openedhand.com>