Use generic txx9 gpio (and gpiolib) for JMR3927 board.
Signed-off-by: NAtsushi Nemoto <anemo@mba.ocn.ne.jp>
Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Convert jmr3927_clock_event_device to more generic
txx9tmr_clock_event_device which supports one-shot mode.  The
txx9tmr_clock_event_device can be used for TX49 too if the cp0 timer
interrupt was not available.

Convert jmr3927_hpt_read to txx9_clocksource driver which does not
depends jiffies anymore.  The txx9_clocksource itself can be used for
TX49, but normally TX49 uses higher precision clocksource_mips.
Signed-off-by: NAtsushi Nemoto <anemo@mba.ocn.ne.jp>
Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Cleanup jmr3927, tx4927 and tx4938 irq codes, using common IRQ_CPU,
I8259 and IRQ_TXX9 irq routines.
Signed-off-by: NAtsushi Nemoto <anemo@mba.ocn.ne.jp>
Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

* Kill dead codes
* Rearrange irq chip handlers
* Minimize defconfig
Signed-off-by: NAtsushi Nemoto <anemo@mba.ocn.ne.jp>
Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

The generic rtc-ds1742 driver can be used for RBTX4927 and JMR3927
(with __swizzle_addr trick).  This patch also removes MIPS local
DS1742 stuff.
Signed-off-by: NAtsushi Nemoto <anemo@mba.ocn.ne.jp>
Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.

Let it rip!