1. 30 10月, 2005 4 次提交
    • H
      [PATCH] mm: update_hiwaters just in time · 365e9c87
      Hugh Dickins 提交于
      update_mem_hiwater has attracted various criticisms, in particular from those
      concerned with mm scalability.  Originally it was called whenever rss or
      total_vm got raised.  Then many of those callsites were replaced by a timer
      tick call from account_system_time.  Now Frank van Maarseveen reports that to
      be found inadequate.  How about this?  Works for Frank.
      
      Replace update_mem_hiwater, a poor combination of two unrelated ops, by macros
      update_hiwater_rss and update_hiwater_vm.  Don't attempt to keep
      mm->hiwater_rss up to date at timer tick, nor every time we raise rss (usually
      by 1): those are hot paths.  Do the opposite, update only when about to lower
      rss (usually by many), or just before final accounting in do_exit.  Handle
      mm->hiwater_vm in the same way, though it's much less of an issue.  Demand
      that whoever collects these hiwater statistics do the work of taking the
      maximum with rss or total_vm.
      
      And there has been no collector of these hiwater statistics in the tree.  The
      new convention needs an example, so match Frank's usage by adding a VmPeak
      line above VmSize to /proc/<pid>/status, and also a VmHWM line above VmRSS
      (High-Water-Mark or High-Water-Memory).
      
      There was a particular anomaly during mremap move, that hiwater_vm might be
      captured too high.  A fleeting such anomaly remains, but it's quickly
      corrected now, whereas before it would stick.
      
      What locking?  None: if the app is racy then these statistics will be racy,
      it's not worth any overhead to make them exact.  But whenever it suits,
      hiwater_vm is updated under exclusive mmap_sem, and hiwater_rss under
      page_table_lock (for now) or with preemption disabled (later on): without
      going to any trouble, minimize the time between reading current values and
      updating, to minimize those occasions when a racing thread bumps a count up
      and back down in between.
      Signed-off-by: NHugh Dickins <hugh@veritas.com>
      Signed-off-by: NAndrew Morton <akpm@osdl.org>
      Signed-off-by: NLinus Torvalds <torvalds@osdl.org>
      365e9c87
    • H
      [PATCH] mm: zap_pte out of line · 861f2fb8
      Hugh Dickins 提交于
      There used to be just one call to zap_pte, but it shouldn't be inline now
      there are two.  Check for the common case pte_none before calling, and move
      its rss accounting up into install_page or install_file_pte - which helps the
      next patch.
      Signed-off-by: NHugh Dickins <hugh@veritas.com>
      Signed-off-by: NAndrew Morton <akpm@osdl.org>
      Signed-off-by: NLinus Torvalds <torvalds@osdl.org>
      861f2fb8
    • N
      [PATCH] core remove PageReserved · b5810039
      Nick Piggin 提交于
      Remove PageReserved() calls from core code by tightening VM_RESERVED
      handling in mm/ to cover PageReserved functionality.
      
      PageReserved special casing is removed from get_page and put_page.
      
      All setting and clearing of PageReserved is retained, and it is now flagged
      in the page_alloc checks to help ensure we don't introduce any refcount
      based freeing of Reserved pages.
      
      MAP_PRIVATE, PROT_WRITE of VM_RESERVED regions is tentatively being
      deprecated.  We never completely handled it correctly anyway, and is be
      reintroduced in future if required (Hugh has a proof of concept).
      
      Once PageReserved() calls are removed from kernel/power/swsusp.c, and all
      arch/ and driver code, the Set and Clear calls, and the PG_reserved bit can
      be trivially removed.
      
      Last real user of PageReserved is swsusp, which uses PageReserved to
      determine whether a struct page points to valid memory or not.  This still
      needs to be addressed (a generic page_is_ram() should work).
      
      A last caveat: the ZERO_PAGE is now refcounted and managed with rmap (and
      thus mapcounted and count towards shared rss).  These writes to the struct
      page could cause excessive cacheline bouncing on big systems.  There are a
      number of ways this could be addressed if it is an issue.
      Signed-off-by: NNick Piggin <npiggin@suse.de>
      
      Refcount bug fix for filemap_xip.c
      Signed-off-by: NCarsten Otte <cotte@de.ibm.com>
      Signed-off-by: NAndrew Morton <akpm@osdl.org>
      Signed-off-by: NLinus Torvalds <torvalds@osdl.org>
      b5810039
    • H
      [PATCH] mm: rss = file_rss + anon_rss · 4294621f
      Hugh Dickins 提交于
      I was lazy when we added anon_rss, and chose to change as few places as
      possible.  So currently each anonymous page has to be counted twice, in rss
      and in anon_rss.  Which won't be so good if those are atomic counts in some
      configurations.
      
      Change that around: keep file_rss and anon_rss separately, and add them
      together (with get_mm_rss macro) when the total is needed - reading two
      atomics is much cheaper than updating two atomics.  And update anon_rss
      upfront, typically in memory.c, not tucked away in page_add_anon_rmap.
      Signed-off-by: NHugh Dickins <hugh@veritas.com>
      Signed-off-by: NAndrew Morton <akpm@osdl.org>
      Signed-off-by: NLinus Torvalds <torvalds@osdl.org>
      4294621f
  2. 12 10月, 2005 1 次提交
  3. 17 4月, 2005 1 次提交
    • L
      Linux-2.6.12-rc2 · 1da177e4
      Linus Torvalds 提交于
      Initial git repository build. I'm not bothering with the full history,
      even though we have it. We can create a separate "historical" git
      archive of that later if we want to, and in the meantime it's about
      3.2GB when imported into git - space that would just make the early
      git days unnecessarily complicated, when we don't have a lot of good
      infrastructure for it.
      
      Let it rip!
      1da177e4