The new FPGA firmware in Balloon3 uses different methods to control it's bus
control lines. In the new version, there are separate registers to set/clear
bus control lines. This patch updates affected places.
Signed-off-by: NMarek Vasut <marek.vasut@gmail.com>
Signed-off-by: NEric Miao <eric.y.miao@gmail.com>

Signed-off-by: NMarek Vasut <marek.vasut@gmail.com>
Signed-off-by: NEric Miao <eric.y.miao@gmail.com>

Signed-off-by: NHaojian Zhuang <haojian.zhuang@marvell.com>
Acked-by: NAntonio Ospite <ospite@studenti.unina.it>
Signed-off-by: NEric Miao <eric.y.miao@gmail.com>

The NAND support is implemented through the gen_nand driver.
Signed-off-by: NMarek Vasut <marek.vasut@gmail.com>

Add supported for PCF8574A GPIO expander and LEDs attached to it.
Signed-off-by: NMarek Vasut <marek.vasut@gmail.com>

This driver adds support for the on-board CF socket.
Signed-off-by: NMarek Vasut <marek.vasut@gmail.com>

Signed-off-by: NEric Miao <eric.y.miao@gmail.com>

So, again against latest pxa-linux-2.6/devel, with the following
changes:

 * Move to __raw_readl/__raw_writel for FPGA/CPLD register access
 * Change Toppoly LCD config to be selectable at run time rather than
   compile time.
 * Remove currently unused irq device suspend/resume functions.
 * Strip out unnecessary/duplicated #includes.
 * Some code style cleanups.

Balloon3 (http://balloonboard.org/) base machine support
Signed-off-by: NJonathan McDowell <noodles@earth.li>
Signed-off-by: NEric Miao <eric.y.miao@gmail.com>