We shouldn't expose the hardware register contents in platform_data.
The only things we allow the user to configure are autoneg, speed, and
duplex.  Add specific platform_data fields for these values and remove
the registers configs.
Signed-off-by: NDale Farnsworth <dale@farnsworth.org>
Signed-off-by: NJeff Garzik <jgarzik@pobox.com>

Use the common ethtool support functions of the MII library.
Add generic MII ioctl handler.
Add PHY parameter speed/duplex/negotiation initialization and modification.
Signed-off-by: NJames Chapman <jchapman@katalix.com>
Signed-off-by: NDale Farnsworth <dale@farnsworth.org>
Signed-off-by: NJeff Garzik <jgarzik@pobox.com>

Modify link up/down handling to use the functions from the MII
library.  Note that I track link state using the MII PHY registers
rather than the mv643xx chip's link state registers because I think
it's cleaner to use the MII library code rather than writing local
driver support code. It is also useful to make the actual MII
registers available to the user with maskable kernel printk messages
so the MII registers are being read anyway
Signed-off-by: NJames Chapman <jchapman@katalix.com>
Signed-off-by: NDale Farnsworth <dale@farnsworth.org>
Signed-off-by: NJeff Garzik <jgarzik@pobox.com>

Add and use the following functions:
	mv643xx_eth_port_enable_tx()
	mv643xx_eth_port_enable_rx()
	mv643xx_eth_port_disable_tx()
	mv643xx_eth_port_disable_rx()

so that ports are enabled/disabled consistently.
Signed-off-by: NDale Farnsworth <dale@farnsworth.org>
Signed-off-by: NJeff Garzik <jgarzik@pobox.com>

tx_ring_skbs is actually a count of tx descriptors currently in use.
Since there may be multiple descriptors per skb, it is not the
same as the number of skbs in the ring.

Also change rx_ring_skbs to rx_desc_count to be consistent.
Signed-off-by: NDale Farnsworth <dale@farnsworth.org>
Signed-off-by: NJeff Garzik <jgarzik@pobox.com>

Remove duplicated code by having unicast and multicast code use
a common filter table function: eth_port_set_filter_table_entry().
Signed-off-by: NDale Farnsworth <dale@farnsworth.org>
Signed-off-by: NJeff Garzik <jgarzik@pobox.com>

mp->port_mac_addr is just a redundant copy of dev->dev_addr, so remove it.
Signed-off-by: NDale Farnsworth <dale@farnsworth.org>
Signed-off-by: NJeff Garzik <jgarzik@pobox.com>

Enable mv643xx_eth driver to work when built as a module on
mv64x60-based embedded systems.
Signed-off-by: NDale Farnsworth <dale@farnsworth.org>
Signed-off-by: NJeff Garzik <jgarzik@pobox.com>

Signed-off-by: NDale Farnsworth <dale@farnsworth.org>
Signed-off-by: NJeff Garzik <jgarzik@pobox.com>

Update dev->last_rx on packet receive

This fix corrects errors seen during configuration of the bonding driver.
Signed-off-by: NPaolo Galtieri <pgaltieri@mvista.com>
Signed-off-by: NDale Farnsworth <dale@farnsworth.org>
Signed-off-by: NJeff Garzik <jgarzik@pobox.com>

This patch eliminates a spinlock recursion bug introduced recently.
Since eth_port_send() is always called with the lock held, we simply
remove the locking inside the function itself.
Signed-off-by: NDale Farnsworth <dale@farnsworth.org>
Signed-off-by: NJeff Garzik <jgarzik@pobox.com>

hi,

this changes if() BUG(); constructs to BUG_ON() which is
cleaner and can better optimized away
Signed-off-by: NEric Sesterhenn <snakebyte@gmx.de>
Signed-off-by: NJeff Garzik <jgarzik@pobox.com>

hi,

this changes if() BUG(); constructs to BUG_ON() which is
cleaner and can better optimized away

One of the if()s contains a call to de_is_running(),
which seems to be safe to replace, but someone with more
knownledge of the code might want to verify this...
Signed-off-by: NEric Sesterhenn <snakebyte@gmx.de>
Signed-off-by: NJeff Garzik <jgarzik@pobox.com>

hi,

this changes if() BUG(); constructs to BUG_ON() which is
cleaner and can better optimized away
Signed-off-by: NEric Sesterhenn <snakebyte@gmx.de>
Signed-off-by: NJeff Garzik <jgarzik@pobox.com>

	There is a problem with fragmented skb in s2io driver version 2.0.9.4
	available in 2.6.16-rc1 kernel. The adapter will fail to transmit if
	any scatter-gather skb arrives.  This patch provides fix for the above
	described problem.
Signed-off-by: NAnanda Raju <ananda.raju@neterion.com>
Signed-off-by: NJeff Garzik <jgarzik@pobox.com>

On my laptop, the b44 device is created and the carrier state defaults
to ON when created by alloc_etherdev. This means tools like NetworkManager
see the carrier as On and try and bring the device up.  The correct thing
to do is mark the carrier as Off when device is created.
Signed-off-by: NStephen Hemminger <shemminger@osdl.org>
Signed-off-by: NJeff Garzik <jgarzik@pobox.com>

tmp in ace_init is u32 thus rendering read_eeprom_byte() return values
checks useless.
Signed-off-by: NEric Sesterhenn <snakebyte@gmx.de>
Signed-off-by: NAlexey Dobriyan <adobriyan@gmail.com>
Signed-off-by: NJeff Garzik <jgarzik@pobox.com>

Since get_settings() returns a signed int and it gets checked
for < 0 to catch an error, res should be a signed int too.
Signed-off-by: NEric Sesterhenn <snakebyte@gmx.de>
Signed-off-by: NAlexey Dobriyan <adobriyan@gmail.com>
Signed-off-by: NJeff Garzik <jgarzik@pobox.com>

Signed-off-by: NDavid S. Miller <davem@davemloft.net>

The compat layer timeout handling changes in:

9f72949f

are busted.  This is most easily seen with an X application
that uses sub-second select/poll timeout such as emacs.  You
hit a key and it takes a second or so before the app responds.

The two ROUND_UP() calls upon entry are using {tv,ts}_sec where it
should instead be using {tv_usec,ts_nsec}, which perfectly explains
the observed incorrect behavior.

Another bug shot down with git bisect.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Or else we break on ppc32 and other 32-bit platforms.

Based upon a patch from Harald Welte.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Fix an unnecessary softlockup watchdog warning in the ia64
uncached_build_memmap() that occurs occasionally at 256p and always at
512p.  The problem occurs at boot time.
Signed-off-by: NJohn Hawkes <hawkes@sgi.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NTony Luck <tony.luck@intel.com>

Migrate perfmon from using an old semaphore to a completion handler.
Signed-off-by: NJes Sorensen <jes@sgi.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NTony Luck <tony.luck@intel.com>

Migrate arch/ia64/ia32/sys_ia32 to using a mutex for mmap protection.
Signed-off-by: NJes Sorensen <jes@sgi.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NTony Luck <tony.luck@intel.com>

This also includes by necessity _TIF_RESTORE_SIGMASK support,
which actually resulted in a lot of cleanups.

The sparc signal handling code is quite a mess and I should
clean it up some day.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NDavid S. Miller <davem@davemloft.net>

some driver clean ups, and a re-posting of changes that are needed

to match the updated TPS.
Signed-off-by: NMark Gross <mark.gross@intel.com>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

This is a subset of the bluesmoke project core code, stripped of the NMI work
which isn't ready to merge and some of the "interesting" proc functionality
that needs reworking or just has no place in kernel.  It requires no core
kernel changes except the added scrub functions already posted.

The goal is to merge further functionality only after the core code is
accepted and proven in the base kernel, and only at the point the upstream
extras are really ready to merge.

From: doug thompson <norsk5@xmission.com>

  This converts EDAC to sysfs and is the final chunk neccessary before EDAC
  has a stable user space API and can be considered for submission into the
  base kernel.
Signed-off-by: NAlan Cox <alan@redhat.com>
Signed-off-by: NAdrian Bunk <bunk@stusta.de>
Signed-off-by: NJesper Juhl <jesper.juhl@gmail.com>
Signed-off-by: Ndoug thompson <norsk5@xmission.com>
Signed-off-by: NPavel Machek <pavel@suse.cz>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Signed-off-by: NAlan Cox <alan@redhat.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Signed-off-by: NAlan Cox <alan@redhat.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Signed-off-by: NAlan Cox <alan@redhat.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

EDAC requires a way to scrub memory if an ECC error is found and the chipset
does not do the work automatically.  That means rewriting memory locations
atomically with respect to all CPUs _and_ bus masters.  That means we can't
use atomic_add(foo, 0) as it gets optimised for non-SMP

This adds a function to include/asm-foo/atomic.h for the platforms currently
supported which implements a scrub of a mapped block.

It also adjusts a few other files include order where atomic.h is included
before types.h as this now causes an error as atomic_scrub uses u32.
Signed-off-by: NAlan Cox <alan@redhat.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Add the sys_pselect6() and sys_poll() calls to the i386 syscall table.
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>