提交 ff66a3c8 编写于 作者: M Minal Shah 提交者: Tony Lindgren

ARM: dts: dra7: add support for parallel NAND flash

DRA7xx platform has in-build GPMC and ELM h/w engines which can be used
for accessing externel NAND flash device. This patch:
- adds generic DT binding in dra7.dtsi for enabling GPMC and ELM h/w engines
- adds DT binding for Micron NAND Flash (MT29F2G16AADWP) present on dra7-evm
*Important*
	On DRA7 EVM, GPMC_WPN and NAND_BOOTn are controlled by DIP switch
	So following board settings are required for NAND device detection:
	SW5.9 (GPMC_WPN) = LOW
	SW5.1 (NAND_BOOTn) = HIGH
Signed-off-by: NMinal Shah <minalkshah@gmail.com>
Signed-off-by: NPekon Gupta <pekon@ti.com>
Reviewed-by: NJavier Martinez Canillas <javier@dowhile0.org>
Signed-off-by: NTony Lindgren <tony@atomide.com>
上级 7b25babf
......@@ -120,6 +120,37 @@
0x284 (PIN_INPUT_SLEW | MUX_MODE0) /* usb2_drvvbus */
>;
};
nand_flash_x16: nand_flash_x16 {
/* On DRA7 EVM, GPMC_WPN and NAND_BOOTn comes from DIP switch
* So NAND flash requires following switch settings:
* SW5.9 (GPMC_WPN) = LOW
* SW5.1 (NAND_BOOTn) = HIGH */
pinctrl-single,pins = <
0x0 (PIN_INPUT | MUX_MODE0) /* gpmc_ad0 */
0x4 (PIN_INPUT | MUX_MODE0) /* gpmc_ad1 */
0x8 (PIN_INPUT | MUX_MODE0) /* gpmc_ad2 */
0xc (PIN_INPUT | MUX_MODE0) /* gpmc_ad3 */
0x10 (PIN_INPUT | MUX_MODE0) /* gpmc_ad4 */
0x14 (PIN_INPUT | MUX_MODE0) /* gpmc_ad5 */
0x18 (PIN_INPUT | MUX_MODE0) /* gpmc_ad6 */
0x1c (PIN_INPUT | MUX_MODE0) /* gpmc_ad7 */
0x20 (PIN_INPUT | MUX_MODE0) /* gpmc_ad8 */
0x24 (PIN_INPUT | MUX_MODE0) /* gpmc_ad9 */
0x28 (PIN_INPUT | MUX_MODE0) /* gpmc_ad10 */
0x2c (PIN_INPUT | MUX_MODE0) /* gpmc_ad11 */
0x30 (PIN_INPUT | MUX_MODE0) /* gpmc_ad12 */
0x34 (PIN_INPUT | MUX_MODE0) /* gpmc_ad13 */
0x38 (PIN_INPUT | MUX_MODE0) /* gpmc_ad14 */
0x3c (PIN_INPUT | MUX_MODE0) /* gpmc_ad15 */
0xd8 (PIN_INPUT_PULLUP | MUX_MODE0) /* gpmc_wait0 */
0xcc (PIN_OUTPUT | MUX_MODE0) /* gpmc_wen */
0xb4 (PIN_OUTPUT_PULLUP | MUX_MODE0) /* gpmc_csn0 */
0xc4 (PIN_OUTPUT | MUX_MODE0) /* gpmc_advn_ale */
0xc8 (PIN_OUTPUT | MUX_MODE0) /* gpmc_oen_ren */
0xd0 (PIN_OUTPUT | MUX_MODE0) /* gpmc_be0n_cle */
>;
};
};
&i2c1 {
......@@ -377,3 +408,90 @@
pinctrl-names = "default";
pinctrl-0 = <&usb2_pins>;
};
&elm {
status = "okay";
};
&gpmc {
status = "okay";
pinctrl-names = "default";
pinctrl-0 = <&nand_flash_x16>;
ranges = <0 0 0 0x01000000>; /* minimum GPMC partition = 16MB */
nand@0,0 {
reg = <0 0 4>; /* device IO registers */
ti,nand-ecc-opt = "bch8";
ti,elm-id = <&elm>;
nand-bus-width = <16>;
gpmc,device-width = <2>;
gpmc,sync-clk-ps = <0>;
gpmc,cs-on-ns = <0>;
gpmc,cs-rd-off-ns = <40>;
gpmc,cs-wr-off-ns = <40>;
gpmc,adv-on-ns = <0>;
gpmc,adv-rd-off-ns = <30>;
gpmc,adv-wr-off-ns = <30>;
gpmc,we-on-ns = <5>;
gpmc,we-off-ns = <25>;
gpmc,oe-on-ns = <2>;
gpmc,oe-off-ns = <20>;
gpmc,access-ns = <20>;
gpmc,wr-access-ns = <40>;
gpmc,rd-cycle-ns = <40>;
gpmc,wr-cycle-ns = <40>;
gpmc,wait-pin = <0>;
gpmc,wait-on-read;
gpmc,wait-on-write;
gpmc,bus-turnaround-ns = <0>;
gpmc,cycle2cycle-delay-ns = <0>;
gpmc,clk-activation-ns = <0>;
gpmc,wait-monitoring-ns = <0>;
gpmc,wr-data-mux-bus-ns = <0>;
/* MTD partition table */
/* All SPL-* partitions are sized to minimal length
* which can be independently programmable. For
* NAND flash this is equal to size of erase-block */
#address-cells = <1>;
#size-cells = <1>;
partition@0 {
label = "NAND.SPL";
reg = <0x00000000 0x000020000>;
};
partition@1 {
label = "NAND.SPL.backup1";
reg = <0x00020000 0x00020000>;
};
partition@2 {
label = "NAND.SPL.backup2";
reg = <0x00040000 0x00020000>;
};
partition@3 {
label = "NAND.SPL.backup3";
reg = <0x00060000 0x00020000>;
};
partition@4 {
label = "NAND.u-boot-spl-os";
reg = <0x00080000 0x00040000>;
};
partition@5 {
label = "NAND.u-boot";
reg = <0x000c0000 0x00100000>;
};
partition@6 {
label = "NAND.u-boot-env";
reg = <0x001c0000 0x00020000>;
};
partition@7 {
label = "NAND.u-boot-env";
reg = <0x001e0000 0x00020000>;
};
partition@8 {
label = "NAND.kernel";
reg = <0x00200000 0x00800000>;
};
partition@9 {
label = "NAND.file-system";
reg = <0x00a00000 0x0f600000>;
};
};
};
......@@ -964,6 +964,26 @@
dr_mode = "otg";
};
};
elm: elm@48078000 {
compatible = "ti,am3352-elm";
reg = <0x48078000 0xfc0>; /* device IO registers */
interrupts = <GIC_SPI 4 IRQ_TYPE_LEVEL_HIGH>;
ti,hwmods = "elm";
status = "disabled";
};
gpmc: gpmc@50000000 {
compatible = "ti,am3352-gpmc";
ti,hwmods = "gpmc";
reg = <0x50000000 0x37c>; /* device IO registers */
interrupts = <GIC_SPI 20 IRQ_TYPE_LEVEL_HIGH>;
gpmc,num-cs = <8>;
gpmc,num-waitpins = <2>;
#address-cells = <2>;
#size-cells = <1>;
status = "disabled";
};
};
};
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册