IB/hfi1: Correct 8051 link parameter settings

Two 8051 link settings, external device config and tuning method,
were written in the wrong location and the previous settings were
not cleared.  For both, clear the old value and write the new
value.

Fixes: 8ebd4cf1 ("staging/rdma/hfi1: Add active and optical cable support")
Reviewed-by: NDennis Dalessandro <dennis.dalessandro@intel.com>
Signed-off-by: NDean Luick <dean.luick@intel.com>
Signed-off-by: NDoug Ledford <dledford@redhat.com>

drivers/infiniband/hw/hfi1/chip.h

@@ -398,6 +398,12 @@
 /* Lane ID for general configuration registers */
 #define GENERAL_CONFIG 4
 
+/* LINK_TUNING_PARAMETERS fields */
+#define TUNING_METHOD_SHIFT 24
+
+/* LINK_OPTIMIZATION_SETTINGS fields */
+#define ENABLE_EXT_DEV_CONFIG_SHIFT 24
+
 /* LOAD_DATA 8051 command shifts and fields */
 #define LOAD_DATA_FIELD_ID_SHIFT 40
 #define LOAD_DATA_FIELD_ID_MASK 0xfull

drivers/infiniband/hw/hfi1/platform.c

@@ -540,7 +540,8 @@ static void apply_tunings(
 	/* Enable external device config if channel is limiting active */
 	read_8051_config(ppd->dd, LINK_OPTIMIZATION_SETTINGS,
 			 GENERAL_CONFIG, &config_data);
-	config_data |= limiting_active;
+	config_data &= ~(0xff << ENABLE_EXT_DEV_CONFIG_SHIFT);
+	config_data |= ((u32)limiting_active << ENABLE_EXT_DEV_CONFIG_SHIFT);
 	ret = load_8051_config(ppd->dd, LINK_OPTIMIZATION_SETTINGS,
 			       GENERAL_CONFIG, config_data);
 	if (ret != HCMD_SUCCESS)
@@ -553,7 +554,8 @@ static void apply_tunings(
 	/* Pass tuning method to 8051 */
 	read_8051_config(ppd->dd, LINK_TUNING_PARAMETERS, GENERAL_CONFIG,
 			 &config_data);
-	config_data |= tuning_method;
+	config_data &= ~(0xff << TUNING_METHOD_SHIFT);
+	config_data |= ((u32)tuning_method << TUNING_METHOD_SHIFT);
 	ret = load_8051_config(ppd->dd, LINK_TUNING_PARAMETERS, GENERAL_CONFIG,
 			       config_data);
 	if (ret != HCMD_SUCCESS)