starfire: Fix dma_addr_t size test for MIPS

Commit 56543af9 "starfire: use BUILD_BUG_ON for netdrv_addr_t" revealed
that the preprocessor condition used to find the size of dma_addr_t
yielded the wrong result for some architectures and configurations.
This was kluged for 64-bit PowerPC in commit 3e502e63 by adding yet
another case to the condition.  However, 64-bit MIPS configurations
are not detected reliably either.

This should be fixed by using CONFIG_ARCH_DMA_ADDR_T_64BIT, but that
isn't yet defined everywhere it should be.
Signed-off-by: NBen Hutchings <ben@decadent.org.uk>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

drivers/net/starfire.c

@@ -148,7 +148,7 @@ static int full_duplex[MAX_UNITS] = {0, };
  * This SUCKS.
  * We need a much better method to determine if dma_addr_t is 64-bit.
  */
-#if (defined(__i386__) && defined(CONFIG_HIGHMEM64G)) || defined(__x86_64__) || defined (__ia64__) || defined(__alpha__) || defined(__mips64__) || (defined(__mips__) && defined(CONFIG_HIGHMEM) && defined(CONFIG_64BIT_PHYS_ADDR)) || (defined(__powerpc64__) || defined(CONFIG_PHYS_64BIT))
+#if (defined(__i386__) && defined(CONFIG_HIGHMEM64G)) || defined(__x86_64__) || defined (__ia64__) || defined(__alpha__) || (defined(CONFIG_MIPS) && ((defined(CONFIG_HIGHMEM) && defined(CONFIG_64BIT_PHYS_ADDR)) || defined(CONFIG_64BIT))) || (defined(__powerpc64__) || defined(CONFIG_PHYS_64BIT))
 /* 64-bit dma_addr_t */
 #define ADDR_64BITS	/* This chip uses 64 bit addresses. */
 #define netdrv_addr_t __le64