can: flexcan: add Transceiver Delay Compensation support

The CAN-FD protocol allows the transmission and reception of data at a
higher bit rate than the nominal rate used in the arbitration phase when
the message's BRS bit is set.

The TDC mechanism is effective only during the data phase of FD frames
having BRS bit set. It has no effect either on non-FD frames, or on FD
frames transmitted at normal bit rate.
Signed-off-by: NJoakim Zhang <qiangqing.zhang@nxp.com>
Link: https://lore.kernel.org/r/20190712075926.7357-7-qiangqing.zhang@nxp.comSigned-off-by: NMarc Kleine-Budde <mkl@pengutronix.de>

drivers/net/can/flexcan.c

@@ -156,6 +156,10 @@
 #define FLEXCAN_FDCTRL_MBDSR_12		0x1
 #define FLEXCAN_FDCTRL_MBDSR_32		0x2
 #define FLEXCAN_FDCTRL_MBDSR_64		0x3
+#define FLEXCAN_FDCTRL_TDCEN		BIT(15)
+#define FLEXCAN_FDCTRL_TDCFAIL		BIT(14)
+#define FLEXCAN_FDCTRL_TDCOFF		GENMASK(12, 8)
+#define FLEXCAN_FDCTRL_TDCVAL		GENMASK(5, 0)
 
 /* FLEXCAN FD Bit Timing register (FDCBT) bits */
 #define FLEXCAN_FDCBT_FPRESDIV_MASK	GENMASK(29, 20)
@@ -1220,11 +1224,24 @@ static void flexcan_set_bittiming_cbt(const struct net_device *dev)
 
 	/* FDCTRL */
 	reg_fdctrl = priv->read(&regs->fdctrl);
-	reg_fdctrl &= ~FLEXCAN_FDCTRL_FDRATE;
+	reg_fdctrl &= ~(FLEXCAN_FDCTRL_FDRATE |
+			FIELD_PREP(FLEXCAN_FDCTRL_TDCOFF, 0x1f));
 
-	if (priv->can.ctrlmode & CAN_CTRLMODE_FD)
+	if (priv->can.ctrlmode & CAN_CTRLMODE_FD) {
 		reg_fdctrl |= FLEXCAN_FDCTRL_FDRATE;
 
+		if (priv->can.ctrlmode & CAN_CTRLMODE_LOOPBACK) {
+			/* TDC must be disabled for Loop Back mode */
+			reg_fdctrl &= ~FLEXCAN_FDCTRL_TDCEN;
+		} else {
+			reg_fdctrl |= FLEXCAN_FDCTRL_TDCEN |
+				FIELD_PREP(FLEXCAN_FDCTRL_TDCOFF,
+					   ((dbt->phase_seg1 - 1) +
+					    dbt->prop_seg + 2) *
+					   ((dbt->brp - 1 ) + 1));
+		}
+	}
+
 	netdev_dbg(dev, "writing fdctrl=0x%08x\n", reg_fdctrl);
 	priv->write(reg_fdctrl, &regs->fdctrl);