net: Fix various misspellings of "connect"

Fix misspellings of "disconnect", "disconnecting", "connections", and
"disconnected".
Signed-off-by: NGeert Uytterhoeven <geert+renesas@glider.be>
Acked-by: NKalle Valo <kvalo@codeaurora.org>
Acked-by: NSimon Horman <horms@verge.net.au>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

drivers/net/wimax/i2400m/usb.c

@@ -511,7 +511,7 @@ int i2400mu_probe(struct usb_interface *iface,
 
 
 /*
- * Disconect a i2400m from the system.
+ * Disconnect a i2400m from the system.
  *
  * i2400m_stop() has been called before, so al the rx and tx contexts
  * have been taken down already. Make sure the queue is stopped,

drivers/net/wireless/realtek/rtlwifi/rtl8192se/hw.c

@@ -1352,9 +1352,9 @@ static void _rtl92s_phy_set_rfhalt(struct ieee80211_hw *hw)
 	/* SW/HW radio off or halt adapter!! For example S3/S4 */
 	} else {
 		/* LED function disable. Power range is about 8mA now. */
-		/* if write 0xF1 disconnet_pci power
+		/* if write 0xF1 disconnect_pci power
 		 *	 ifconfig wlan0 down power are both high 35:70 */
-		/* if write oxF9 disconnet_pci power
+		/* if write oxF9 disconnect_pci power
 		 * ifconfig wlan0 down power are both low  12:45*/
 		rtl_write_byte(rtlpriv, 0x03, 0xF9);
 	}

include/net/cfg80211.h

@@ -6593,7 +6593,7 @@ struct cfg80211_roam_info {
  * time it is accessed in __cfg80211_roamed() due to delay in scheduling
  * rdev->event_work. In case of any failures, the reference is released
  * either in cfg80211_roamed() or in __cfg80211_romed(), Otherwise, it will be
- * released while diconneting from the current bss.
+ * released while disconnecting from the current bss.
  */
 void cfg80211_roamed(struct net_device *dev, struct cfg80211_roam_info *info,
 		     gfp_t gfp);

net/netfilter/ipvs/ip_vs_ovf.c

@@ -5,7 +5,7 @@
  * Authors:     Raducu Deaconu <rhadoo_io@yahoo.com>
  *
  * Scheduler implements "overflow" loadbalancing according to number of active
- * connections , will keep all conections to the node with the highest weight
+ * connections , will keep all connections to the node with the highest weight
  * and overflow to the next node if the number of connections exceeds the node's
  * weight.
  * Note that this scheduler might not be suitable for UDP because it only uses

net/wireless/reg.h

@@ -114,7 +114,7 @@ void regulatory_hint_country_ie(struct wiphy *wiphy,
 			 u8 country_ie_len);
 
 /**
- * regulatory_hint_disconnect - informs all devices have been disconneted
+ * regulatory_hint_disconnect - informs all devices have been disconnected
  *
  * Regulotory rules can be enhanced further upon scanning and upon
  * connection to an AP. These rules become stale if we disconnect