atm: [iphase] doesn't call phy->start due to a bogus #ifndef

This causes the suni driver to oops if you try to use sonetdiag to get
the statistics. Also add the corresponding phy->stop call to fix another
oops if you try to remove the module.
Signed-off-by: NJorge Boncompte [DTI2] <jorge@dti2.net>
Signed-off-by: NChas Williams <chas@cmf.nrl.navy.mil>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

drivers/atm/iphase.c

@@ -2562,17 +2562,11 @@ static int __devinit ia_start(struct atm_dev *dev)
 		error = suni_init(dev);
 		if (error)
 			goto err_free_rx;
-		/* 
-		 * Enable interrupt on loss of signal
-		 * SUNI_RSOP_CIE - 0x10
-		 * SUNI_RSOP_CIE_LOSE - 0x04
-		 */
-		ia_phy_put(dev, ia_phy_get(dev, 0x10) | 0x04, 0x10);
-#ifndef MODULE
-		error = dev->phy->start(dev);
-		if (error)
-			goto err_free_rx;
-#endif
+		if (dev->phy->start) {
+			error = dev->phy->start(dev);
+			if (error)
+				goto err_free_rx;
+		}
 		/* Get iadev->carrier_detect status */
 		IaFrontEndIntr(iadev);
 	}
@@ -3238,9 +3232,14 @@ static void __devexit ia_remove_one(struct pci_dev *pdev)
 	struct atm_dev *dev = pci_get_drvdata(pdev);
 	IADEV *iadev = INPH_IA_DEV(dev);
 
-	ia_phy_put(dev, ia_phy_get(dev,0x10) & ~(0x4), 0x10); 
+	/* Disable phy interrupts */
+	ia_phy_put(dev, ia_phy_get(dev, SUNI_RSOP_CIE) & ~(SUNI_RSOP_CIE_LOSE),
+				   SUNI_RSOP_CIE);
 	udelay(1);
 
+	if (dev->phy && dev->phy->stop)
+		dev->phy->stop(dev);
+
 	/* De-register device */  
       	free_irq(iadev->irq, dev);
 	iadev_count--;