提交 d2b18394 编写于 作者: R Russell King 提交者: Russell King

[MMC] Set correct capacity for 1024-byte block cards

We were passing set_capacity() the capacity we calculated in terms of
the number of blocks on the card, which happened to be the right units
for 512-byte block cards.  However, with 1024-byte block cards, we
end up setting the capacity to half the number of blocks.  Fix this
by shifting by the appropriate amount.

Thanks to Todd Blumer for pointing this out.

Use get_capacity() to report the card capacity, rather than
recalculating it from the CSD information.

Finally, use our chosen IO block size for the SET_BLOCKLEN command
rather than the CSD read block size.  Currently these are equivalent,
but will not be in the future.
Signed-off-by: NRussell King <rmk+kernel@arm.linux.org.uk>
上级 d5ea4e26
......@@ -359,7 +359,12 @@ static struct mmc_blk_data *mmc_blk_alloc(struct mmc_card *card)
md->block_bits = card->csd.read_blkbits;
blk_queue_hardsect_size(md->queue.queue, 1 << md->block_bits);
set_capacity(md->disk, card->csd.capacity);
/*
* The CSD capacity field is in units of read_blkbits.
* set_capacity takes units of 512 bytes.
*/
set_capacity(md->disk, card->csd.capacity << (card->csd.read_blkbits - 9));
}
out:
return md;
......@@ -373,7 +378,7 @@ mmc_blk_set_blksize(struct mmc_blk_data *md, struct mmc_card *card)
mmc_card_claim_host(card);
cmd.opcode = MMC_SET_BLOCKLEN;
cmd.arg = 1 << card->csd.read_blkbits;
cmd.arg = 1 << md->block_bits;
cmd.flags = MMC_RSP_R1;
err = mmc_wait_for_cmd(card->host, &cmd, 5);
mmc_card_release_host(card);
......@@ -412,10 +417,9 @@ static int mmc_blk_probe(struct mmc_card *card)
if (err)
goto out;
printk(KERN_INFO "%s: %s %s %dKiB %s\n",
printk(KERN_INFO "%s: %s %s %luKiB %s\n",
md->disk->disk_name, mmc_card_id(card), mmc_card_name(card),
(card->csd.capacity << card->csd.read_blkbits) / 1024,
mmc_blk_readonly(card)?"(ro)":"");
get_capacity(md->disk) >> 1, mmc_blk_readonly(card)?"(ro)":"");
mmc_set_drvdata(card, md);
add_disk(md->disk);
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册