ixgbe: fix linking at 100Mbps on copper devices with MNG FW enabled

Driver was calling setup_link to make sure that fiber interfaces with MNG FW
enabled will get link on probe because the laser was most likely turned off.
This prevented non-fiber devices with MNG FW from linking at 100Mbps.

This patch adds a check to only call setup_link for fiber devices.
Reported-and-by: NTony Luck <tony.luck@intel.com>
Signed-off-by: NEmil Tantilov <emil.s.tantilov@intel.com>
Tested-by: NTony Luck <tony.luck@intel.com>
Tested-by: NPhil Schmitt <phillip.j.schmitt@intel.com>
Signed-off-by: NJeff Kirsher <jeffrey.t.kirsher@intel.com>

drivers/net/ethernet/intel/ixgbe/ixgbe_main.c

@@ -8449,8 +8449,8 @@ static int ixgbe_probe(struct pci_dev *pdev, const struct pci_device_id *ent)
 
 	ixgbe_dbg_adapter_init(adapter);
 
-	/* Need link setup for MNG FW, else wait for IXGBE_UP */
-	if (ixgbe_mng_enabled(hw) && hw->mac.ops.setup_link)
+	/* setup link for SFP devices with MNG FW, else wait for IXGBE_UP */
+	if (ixgbe_mng_enabled(hw) && ixgbe_is_sfp(hw) && hw->mac.ops.setup_link)
 		hw->mac.ops.setup_link(hw,
 			IXGBE_LINK_SPEED_10GB_FULL | IXGBE_LINK_SPEED_1GB_FULL,
 			true);