提交 d0f2677b 编写于 作者: M Maxime Ripard

ARM: sunxi: Add Olimex A10s-Olinuxino-micro device tree

Signed-off-by: NMaxime Ripard <maxime.ripard@free-electrons.com>
Tested-by: NEmilio López <emilio@elopez.com.ar>
Acked-by: NEmilio López <emilio@elopez.com.ar>
上级 d3ae078e
......@@ -179,6 +179,7 @@ dtb-$(CONFIG_ARCH_SPEAR3XX)+= spear300-evb.dtb \
dtb-$(CONFIG_ARCH_SPEAR6XX)+= spear600-evb.dtb
dtb-$(CONFIG_ARCH_SUNXI) += sun4i-a10-cubieboard.dtb \
sun4i-a10-hackberry.dtb \
sun5i-a10s-olinuxino-micro.dtb \
sun5i-a13-olinuxino.dtb
dtb-$(CONFIG_ARCH_TEGRA) += tegra20-harmony.dtb \
tegra20-iris-512.dtb \
......
/*
* Copyright 2013 Maxime Ripard
*
* Maxime Ripard <maxime.ripard@free-electrons.com>
*
* The code contained herein is licensed under the GNU General Public
* License. You may obtain a copy of the GNU General Public License
* Version 2 or later at the following locations:
*
* http://www.opensource.org/licenses/gpl-license.html
* http://www.gnu.org/copyleft/gpl.html
*/
/dts-v1/;
/include/ "sun5i-a10s.dtsi"
/ {
model = "Olimex A10s-Olinuxino Micro";
compatible = "olimex,a10s-olinuxino-micro", "allwinner,sun5i-a10s";
soc@01c20000 {
emac: ethernet@01c0b000 {
pinctrl-names = "default";
pinctrl-0 = <&emac_pins_a>;
phy = <&phy1>;
status = "okay";
};
mdio@01c0b080 {
status = "okay";
phy1: ethernet-phy@1 {
reg = <1>;
};
};
pinctrl@01c20800 {
led_pins_olinuxino: led_pins@0 {
allwinner,pins = "PE3";
allwinner,function = "gpio_out";
allwinner,drive = <1>;
allwinner,pull = <0>;
};
};
uart0: serial@01c28000 {
pinctrl-names = "default";
pinctrl-0 = <&uart0_pins_a>;
status = "okay";
};
uart2: serial@01c28800 {
pinctrl-names = "default";
pinctrl-0 = <&uart2_pins_a>;
status = "okay";
};
uart3: serial@01c28c00 {
pinctrl-names = "default";
pinctrl-0 = <&uart3_pins_a>;
status = "okay";
};
};
leds {
compatible = "gpio-leds";
pinctrl-names = "default";
pinctrl-0 = <&led_pins_olinuxino>;
green {
label = "a10s-olinuxino-micro:green:usr";
gpios = <&pio 4 3 0>;
default-state = "on";
};
};
};
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册