提交 cee25168 编写于 作者: J Jani Nikula 提交者: Daniel Vetter

drm/i915: ensure i2c adapter is all set before adding it

i2c_add_adapter() may do i2c transfers on the bus to detect supported
devices. Therefore the adapter needs to be all set before adding it. This
was not the case for the bit-banging fallback, resulting in an oops if the
device detection GMBUS transfers timed out. Fix the issue by calling
i2c_add_adapter() only after intel_gpio_setup().

LKML-Reference: <5021F00B.7000503@ionic.de>
Tested-by: NMihai Moldovan <ionic@ionic.de>
Signed-off-by: NJani Nikula <jani.nikula@intel.com>
Signed-off-by: NDaniel Vetter <daniel.vetter@ffwll.ch>
上级 4344b813
......@@ -486,9 +486,6 @@ int intel_setup_gmbus(struct drm_device *dev)
bus->dev_priv = dev_priv;
bus->adapter.algo = &gmbus_algorithm;
ret = i2c_add_adapter(&bus->adapter);
if (ret)
goto err;
/* By default use a conservative clock rate */
bus->reg0 = port | GMBUS_RATE_100KHZ;
......@@ -498,6 +495,10 @@ int intel_setup_gmbus(struct drm_device *dev)
bus->force_bit = true;
intel_gpio_setup(bus, port);
ret = i2c_add_adapter(&bus->adapter);
if (ret)
goto err;
}
intel_i2c_reset(dev_priv->dev);
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册