Input: ti_am335x_tsc - fix spelling mistake in TSC/ADC DT binding

There was a spelling mistake on TSC/ADC binding where "coordinate" was
spelled as "coordiante".

We can't simply fix the error due to DT being an ABI, the approach taken
was to first use correct spelling and if that fails, fall back to
miss-spelled version.

It's unfortunate that has creeped into the tree.
Signed-off-by: NFelipe Balbi <balbi@ti.com>
Signed-off-by: NDmitry Torokhov <dmitry.torokhov@gmail.com>

Documentation/devicetree/bindings/input/touchscreen/ti-tsc-adc.txt

@@ -6,7 +6,7 @@ Required properties:
 	ti,wires: Wires refer to application modes i.e. 4/5/8 wire touchscreen
 		  support on the platform.
 	ti,x-plate-resistance: X plate resistance
-	ti,coordiante-readouts: The sequencer supports a total of 16
+	ti,coordinate-readouts: The sequencer supports a total of 16
 				programmable steps each step is used to
 				read a single coordinate. A single
                                 readout is enough but multiple reads can

arch/arm/boot/dts/am335x-evm.dts

@@ -509,7 +509,7 @@
 	tsc {
 		ti,wires = <4>;
 		ti,x-plate-resistance = <200>;
-		ti,coordiante-readouts = <5>;
+		ti,coordinate-readouts = <5>;
 		ti,wire-config = <0x00 0x11 0x22 0x33>;
 	};
 

drivers/input/touchscreen/ti_am335x_tsc.c

@@ -348,8 +348,15 @@ static int titsc_parse_dt(struct platform_device *pdev,
 	if (err < 0)
 		return err;
 
-	err = of_property_read_u32(node, "ti,coordiante-readouts",
+	/*
+	 * Try with the new binding first. If it fails, try again with
+	 * bogus, miss-spelled version.
+	 */
+	err = of_property_read_u32(node, "ti,coordinate-readouts",
 			&ts_dev->coordinate_readouts);
+	if (err < 0)
+		err = of_property_read_u32(node, "ti,coordiante-readouts",
+				&ts_dev->coordinate_readouts);
 	if (err < 0)
 		return err;