RDMA/mlx5: Clear old rate limit when closing QP

Before QP is closed it changes to ERROR state, when this happens
the QP was left with old rate limit that was already removed from
the table.

Fixes: 7d29f349 ("IB/mlx5: Properly adjust rate limit on QP state transitions")
Signed-off-by: NRafi Wiener <rafiw@mellanox.com>
Signed-off-by: NOleg Kuporosov <olegk@mellanox.com>
Signed-off-by: NLeon Romanovsky <leonro@mellanox.com>
Link: https://lore.kernel.org/r/20191002120243.16971-1-leon@kernel.orgSigned-off-by: NDoug Ledford <dledford@redhat.com>

drivers/infiniband/hw/mlx5/qp.c

@@ -3249,10 +3249,12 @@ static int modify_raw_packet_qp_sq(
 	}
 
 	/* Only remove the old rate after new rate was set */
-	if ((old_rl.rate &&
-	     !mlx5_rl_are_equal(&old_rl, &new_rl)) ||
-	    (new_state != MLX5_SQC_STATE_RDY))
+	if ((old_rl.rate && !mlx5_rl_are_equal(&old_rl, &new_rl)) ||
+	    (new_state != MLX5_SQC_STATE_RDY)) {
 		mlx5_rl_remove_rate(dev, &old_rl);
+		if (new_state != MLX5_SQC_STATE_RDY)
+			memset(&new_rl, 0, sizeof(new_rl));
+	}
 
 	ibqp->rl = new_rl;
 	sq->state = new_state;