i2c: recovery: make pin init look like STOP

When we initialize the pins, make sure it looks like STOP by dividing
the delay into halves. It shouldn't matter because SDA is expected to be
held low by a device, but for super-safety, let's do it.
Signed-off-by: NWolfram Sang <wsa+renesas@sang-engineering.com>
Reviewed-by: NUlrich Hecht <ulrich.hecht+renesas@gmail.com>
Reviewed-by: NPeter Rosin <peda@axentia.se>
Signed-off-by: NWolfram Sang <wsa@the-dreams.de>

drivers/i2c/i2c-core-base.c

@@ -190,10 +190,17 @@ int i2c_generic_scl_recovery(struct i2c_adapter *adap)
 	if (bri->prepare_recovery)
 		bri->prepare_recovery(adap);
 
+	/*
+	 * If we can set SDA, we will always create a STOP to ensure additional
+	 * pulses will do no harm. This is achieved by letting SDA follow SCL
+	 * half a cycle later. Check the 'incomplete_write_byte' fault injector
+	 * for details.
+	 */
 	bri->set_scl(adap, scl);
+	ndelay(RECOVERY_NDELAY / 2);
 	if (bri->set_sda)
-		bri->set_sda(adap, 1);
-	ndelay(RECOVERY_NDELAY);
+		bri->set_sda(adap, scl);
+	ndelay(RECOVERY_NDELAY / 2);
 
 	/*
 	 * By this time SCL is high, as we need to give 9 falling-rising edges
@@ -211,13 +218,7 @@ int i2c_generic_scl_recovery(struct i2c_adapter *adap)
 
 		scl = !scl;
 		bri->set_scl(adap, scl);
-
-		/*
-		 * If we can set SDA, we will always create STOP here to ensure
-		 * the additional pulses will do no harm. This is achieved by
-		 * letting SDA follow SCL half a cycle later. Check the
-		 * 'incomplete_write_byte' fault injector for details.
-		 */
+		/* Creating STOP again, see above */
 		ndelay(RECOVERY_NDELAY / 2);
 		if (bri->set_sda)
 			bri->set_sda(adap, scl);