btrfs: zoned: add a dedicated data relocation block group
Relocation in a zoned filesystem can fail with a transaction abort with error -22 (EINVAL). This happens because the relocation code assumes that the extents we relocated the data to have the same size the source extents had and ensures this by preallocating the extents. But in a zoned filesystem we currently can't preallocate the extents as this would break the sequential write required rule. Therefore it can happen that the writeback process kicks in while we're still adding pages to a delalloc range and starts writing out dirty pages. This then creates destination extents that are smaller than the source extents, triggering the following safety check in get_new_location(): 1034 if (num_bytes != btrfs_file_extent_disk_num_bytes(leaf, fi)) { 1035 ret = -EINVAL; 1036 goto out; 1037 } Temporarily create a dedicated block group for the relocation process, so no non-relocation data writes can interfere with the relocation writes. This is needed that we can switch the relocation process on a zoned filesystem from the REQ_OP_ZONE_APPEND writing we use for data to a scheme like in a non-zoned filesystem using REQ_OP_WRITE and preallocation. Fixes: 32430c61 ("btrfs: zoned: enable relocation on a zoned filesystem") Reviewed-by: NNaohiro Aota <naohiro.aota@wdc.com> Signed-off-by: NJohannes Thumshirn <johannes.thumshirn@wdc.com> Reviewed-by: NDavid Sterba <dsterba@suse.com> Signed-off-by: NDavid Sterba <dsterba@suse.com>
Showing
想要评论请 注册 或 登录