md/raid5: avoid an extra write when writing to a known-bad-block.

If we write to a known-bad-block it will be flags as having
a ReadError by analyse_stripe, but the write will proceed anyway
(as it should).  Then the read-error handling will kick in an
write again, then re-read.

We don't need that 'write-again', so set R5_ReWrite so it looks like
it has already been done.  Then we will just get the re-read, which we
want.
Reported-by: Nmajianpeng <majianpeng@gmail.com>
Signed-off-by: NNeilBrown <neilb@suse.de>

drivers/md/raid5.c

@@ -1887,8 +1887,15 @@ static void raid5_end_write_request(struct bio *bi, int error)
 					&rdev->mddev->recovery);
 		} else if (is_badblock(rdev, sh->sector,
 				       STRIPE_SECTORS,
-				       &first_bad, &bad_sectors))
+				       &first_bad, &bad_sectors)) {
 			set_bit(R5_MadeGood, &sh->dev[i].flags);
+			if (test_bit(R5_ReadError, &sh->dev[i].flags))
+				/* That was a successful write so make
+				 * sure it looks like we already did
+				 * a re-write.
+				 */
+				set_bit(R5_ReWrite, &sh->dev[i].flags);
+		}
 	}
 	rdev_dec_pending(rdev, conf->mddev);