fm10k: update netdev perm_addr during reinit, instead of at up

Update the netdev permanent address during fm10k_reinit enables the user
to immediately see the new MAC address on the VF even if the device
isn't up. The previous code required that the device by opened before
changes would appear.
Signed-off-by: NJacob Keller <jacob.e.keller@intel.com>
Tested-by: NKrishneil Singh <krishneil.k.singh@intel.com>
Signed-off-by: NJeff Kirsher <jeffrey.t.kirsher@intel.com>

drivers/net/ethernet/intel/fm10k/fm10k_netdev.c

@@ -996,21 +996,6 @@ void fm10k_restore_rx_state(struct fm10k_intfc *interface)
 	int xcast_mode;
 	u16 vid, glort;
 
-	/* restore our address if perm_addr is set */
-	if (hw->mac.type == fm10k_mac_vf) {
-		if (is_valid_ether_addr(hw->mac.perm_addr)) {
-			ether_addr_copy(hw->mac.addr, hw->mac.perm_addr);
-			ether_addr_copy(netdev->perm_addr, hw->mac.perm_addr);
-			ether_addr_copy(netdev->dev_addr, hw->mac.perm_addr);
-			netdev->addr_assign_type &= ~NET_ADDR_RANDOM;
-		}
-
-		if (hw->mac.vlan_override)
-			netdev->features &= ~NETIF_F_HW_VLAN_CTAG_RX;
-		else
-			netdev->features |= NETIF_F_HW_VLAN_CTAG_RX;
-	}
-
 	/* record glort for this interface */
 	glort = interface->glort;
 

drivers/net/ethernet/intel/fm10k/fm10k_pci.c

@@ -170,6 +170,21 @@ static void fm10k_reinit(struct fm10k_intfc *interface)
 	/* reassociate interrupts */
 	fm10k_mbx_request_irq(interface);
 
+	/* update hardware address for VFs if perm_addr has changed */
+	if (hw->mac.type == fm10k_mac_vf) {
+		if (is_valid_ether_addr(hw->mac.perm_addr)) {
+			ether_addr_copy(hw->mac.addr, hw->mac.perm_addr);
+			ether_addr_copy(netdev->perm_addr, hw->mac.perm_addr);
+			ether_addr_copy(netdev->dev_addr, hw->mac.perm_addr);
+			netdev->addr_assign_type &= ~NET_ADDR_RANDOM;
+		}
+
+		if (hw->mac.vlan_override)
+			netdev->features &= ~NETIF_F_HW_VLAN_CTAG_RX;
+		else
+			netdev->features |= NETIF_F_HW_VLAN_CTAG_RX;
+	}
+
 	/* reset clock */
 	fm10k_ts_reset(interface);