ath10k: apply Mesh subtype when Mesh interface created.

QCA988X firmware starting from 10.2.4.70.12-2 has capability to support
Mesh Control Field Present bit in QoS field in native Wi-Fi mode.
Hence apply Mesh subtype according to the WMI service map.

Firmware will allows unicast, broadcast, multicast, and WDS frame
(FromDS = 1 and ToDS = 1) to be received via the interface, once Mesh
subtype is used.

The firmware and this patch together make native Wi-Fi mode comply to
IEEE802.11s Mesh frame in open mode, but the firmware doesn't yet
support secured Mesh mode.
Signed-off-by: NPeter Oh <poh@qca.qualcomm.com>
Signed-off-by: NKalle Valo <kvalo@qca.qualcomm.com>

drivers/net/wireless/ath/ath10k/mac.c

@@ -4364,7 +4364,9 @@ static int ath10k_add_interface(struct ieee80211_hw *hw,
 		arvif->vdev_type = WMI_VDEV_TYPE_IBSS;
 		break;
 	case NL80211_IFTYPE_MESH_POINT:
-		if (!test_bit(ATH10K_FLAG_RAW_MODE, &ar->dev_flags)) {
+		if (test_bit(WMI_SERVICE_MESH, ar->wmi.svc_map)) {
+			arvif->vdev_subtype = WMI_VDEV_SUBTYPE_MESH;
+		} else if (!test_bit(ATH10K_FLAG_RAW_MODE, &ar->dev_flags)) {
 			ret = -EINVAL;
 			ath10k_warn(ar, "must load driver with rawmode=1 to add mesh interfaces\n");
 			goto err;