提交 ba3823ca 编写于 作者: D David S. Miller

Merge branch 'Fixes-for-OF_MDIO-flag'

Dan Murphy says:

====================
Fixes for OF_MDIO flag

There are some residual drivers that check the CONFIG_OF_MDIO flag using the
if defs. Using this check does not work when the OF_MDIO is configured as a
module. Using the IS_ENABLED macro checks if the flag is declared as built-in
or as a module.
====================
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
......@@ -488,7 +488,7 @@ static int dp83867_verify_rgmii_cfg(struct phy_device *phydev)
return 0;
}
#ifdef CONFIG_OF_MDIO
#if IS_ENABLED(CONFIG_OF_MDIO)
static int dp83867_of_init(struct phy_device *phydev)
{
struct dp83867_private *dp83867 = phydev->priv;
......
......@@ -176,7 +176,7 @@ static int dp83869_set_strapped_mode(struct phy_device *phydev)
return 0;
}
#ifdef CONFIG_OF_MDIO
#if IS_ENABLED(CONFIG_OF_MDIO)
static int dp83869_of_init(struct phy_device *phydev)
{
struct dp83869_private *dp83869 = phydev->priv;
......
......@@ -429,7 +429,7 @@ static int m88e1101_config_aneg(struct phy_device *phydev)
return marvell_config_aneg(phydev);
}
#ifdef CONFIG_OF_MDIO
#if IS_ENABLED(CONFIG_OF_MDIO)
/* Set and/or override some configuration registers based on the
* marvell,reg-init property stored in the of_node for the phydev.
*
......
......@@ -374,7 +374,7 @@ struct vsc8531_private {
#endif
};
#ifdef CONFIG_OF_MDIO
#if IS_ENABLED(CONFIG_OF_MDIO)
struct vsc8531_edge_rate_table {
u32 vddmac;
u32 slowdown[8];
......
......@@ -98,7 +98,7 @@ static const struct vsc85xx_hw_stat vsc8584_hw_stats[] = {
},
};
#ifdef CONFIG_OF_MDIO
#if IS_ENABLED(CONFIG_OF_MDIO)
static const struct vsc8531_edge_rate_table edge_table[] = {
{MSCC_VDDMAC_3300, { 0, 2, 4, 7, 10, 17, 29, 53} },
{MSCC_VDDMAC_2500, { 0, 3, 6, 10, 14, 23, 37, 63} },
......@@ -382,7 +382,7 @@ static void vsc85xx_wol_get(struct phy_device *phydev,
mutex_unlock(&phydev->lock);
}
#ifdef CONFIG_OF_MDIO
#if IS_ENABLED(CONFIG_OF_MDIO)
static int vsc85xx_edge_rate_magic_get(struct phy_device *phydev)
{
u32 vdd, sd;
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册