stmmac: fix DMA channel hang in half-duplex mode

HW does not support Half-duplex mode in multi-queue
scenario. Fix it by not advertising the Half-Duplex
mode if multi-queue enabled.
Signed-off-by: NBhadram Varka <vbhadram@nvidia.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

drivers/net/ethernet/stmicro/stmmac/stmmac_main.c

@@ -928,6 +928,7 @@ static void stmmac_check_pcs_mode(struct stmmac_priv *priv)
 static int stmmac_init_phy(struct net_device *dev)
 {
 	struct stmmac_priv *priv = netdev_priv(dev);
+	u32 tx_cnt = priv->plat->tx_queues_to_use;
 	struct phy_device *phydev;
 	char phy_id_fmt[MII_BUS_ID_SIZE + 3];
 	char bus_id[MII_BUS_ID_SIZE];
@@ -968,6 +969,15 @@ static int stmmac_init_phy(struct net_device *dev)
 		phydev->advertising &= ~(SUPPORTED_1000baseT_Half |
 					 SUPPORTED_1000baseT_Full);
 
+	/*
+	 * Half-duplex mode not supported with multiqueue
+	 * half-duplex can only works with single queue
+	 */
+	if (tx_cnt > 1)
+		phydev->supported &= ~(SUPPORTED_1000baseT_Half |
+				       SUPPORTED_100baseT_Half |
+				       SUPPORTED_10baseT_Half);
+
 	/*
 	 * Broken HW is sometimes missing the pull-up resistor on the
 	 * MDIO line, which results in reads to non-existent devices returning