IPoIB: Don't drop multicast sends when they can be queued

When set_multicast_list() is called the multicast task is restarted
and the IPOIB_MCAST_STARTED bit is cleared.  As a result for some
window of time, multicast packets are not transmitted nor queued but
rather dropped by ipoib_mcast_send().  These dropped packets are
painful in two cases:

 - bonding fail-over which both calls set_multicast_list() on the new
   active slave and sends Gratuitous ARP through that slave.

 - IP_DROP_MEMBERSHIP code which both calls set_multicast_list() on the
   device and issues IGMP leave.

In both these cases, depending on the scheduling of the IPoIB
multicast task, the packets would be dropped.  As a result, in the
bonding case, the failover would not be detected by the peers until
their neighbour is renewed the neighbour (which takes a few tens of
seconds).  In the IGMP case, the IP router doesn't get an IGMP leave
and would only learn on that from further probes on the group (also a
delay of at least a few tens of seconds).

Fix this by allowing transmission (or queuing) depending on the
IPOIB_FLAG_OPER_UP flag instead of the IPOIB_MCAST_STARTED flag.
Signed-off-by: NOlga Shern <olgas@voltaire.com>
Signed-off-by: NOr Gerlitz <ogerlitz@voltaire.com>
Signed-off-by: NRoland Dreier <rolandd@cisco.com>

drivers/infiniband/ulp/ipoib/ipoib_multicast.c

@@ -650,7 +650,7 @@ void ipoib_mcast_send(struct net_device *dev, void *mgid, struct sk_buff *skb)
 	 */
 	spin_lock(&priv->lock);
 
-	if (!test_bit(IPOIB_MCAST_STARTED, &priv->flags)	||
+	if (!test_bit(IPOIB_FLAG_OPER_UP, &priv->flags)		||
 	    !priv->broadcast					||
 	    !test_bit(IPOIB_MCAST_FLAG_ATTACHED, &priv->broadcast->flags)) {
 		++dev->stats.tx_dropped;