提交 b2c08299 编写于 作者: J Jaegeuk Kim

f2fs: do checkpoint for the renamed inode

If an inode is renamed, it should be registered as file_lost_pino to conduct
checkpoint at f2fs_sync_file.
Otherwise, the inode cannot be recovered due to no dent_mark in the following
scenario.

Note that, this scenario is from xfstests/322.

1. create "a"
2. fsync "a"
3. rename "a" to "b"
4. fsync "b"
5. Sudden power-cut

After recovery is done, "b" should be seen.
However, the result shows "a", since the recovery procedure does not enter
recover_dentry due to no dent_mark.

The reason is like below.
- The nid of "a" is checkpointed during #2, f2fs_sync_file.
- The inode page for "b" produced by #3 is written without dent_mark by
sync_node_pages.

So, this patch fixes this bug by assinging file_lost_pino to the "a"'s inode.
If the pino is lost, f2fs_sync_file conducts checkpoint, and then recovers
the latest pino and its dentry information for further recovery.
Signed-off-by: NJaegeuk Kim <jaegeuk@kernel.org>
上级 dd4d961f
......@@ -417,9 +417,6 @@ static int f2fs_rename(struct inode *old_dir, struct dentry *old_dentry,
}
f2fs_set_link(new_dir, new_entry, new_page, old_inode);
down_write(&F2FS_I(old_inode)->i_sem);
F2FS_I(old_inode)->i_pino = new_dir->i_ino;
up_write(&F2FS_I(old_inode)->i_sem);
new_inode->i_ctime = CURRENT_TIME;
down_write(&F2FS_I(new_inode)->i_sem);
......@@ -448,6 +445,10 @@ static int f2fs_rename(struct inode *old_dir, struct dentry *old_dentry,
}
}
down_write(&F2FS_I(old_inode)->i_sem);
file_lost_pino(old_inode);
up_write(&F2FS_I(old_inode)->i_sem);
old_inode->i_ctime = CURRENT_TIME;
mark_inode_dirty(old_inode);
......@@ -457,9 +458,6 @@ static int f2fs_rename(struct inode *old_dir, struct dentry *old_dentry,
if (old_dir != new_dir) {
f2fs_set_link(old_inode, old_dir_entry,
old_dir_page, new_dir);
down_write(&F2FS_I(old_inode)->i_sem);
F2FS_I(old_inode)->i_pino = new_dir->i_ino;
up_write(&F2FS_I(old_inode)->i_sem);
update_inode_page(old_inode);
} else {
kunmap(old_dir_page);
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册