xhci: Remove references to HC_STATE_RUNNING.

The USB core will set hcd->state to HC_STATE_RUNNING before calling
xhci_run, so there's no point in setting it twice.  The USB core also
doesn't pay attention to HC_STATE_RUNNING on the resume path anymore; it
uses HCD_RH_RUNNING(), which looks at hcd->flags & (1U <<
HCD_FLAG_RH_RUNNING.  Therefore, it's safe to remove the state set in
xhci_bus_resume().
Signed-off-by: NSarah Sharp <sarah.a.sharp@linux.intel.com>

drivers/usb/host/xhci-hub.c

@@ -732,7 +732,6 @@ int xhci_bus_resume(struct usb_hcd *hcd)
 	(void) xhci_readl(xhci, &xhci->op_regs->command);
 
 	xhci->next_statechange = jiffies + msecs_to_jiffies(5);
-	hcd->state = HC_STATE_RUNNING;
 	/* re-enable irqs */
 	temp = xhci_readl(xhci, &xhci->op_regs->command);
 	temp |= CMD_EIE;

drivers/usb/host/xhci.c

@@ -452,7 +452,6 @@ int xhci_run(struct usb_hcd *hcd)
 	xhci_writel(xhci, temp, &xhci->ir_set->irq_control);
 
 	/* Set the HCD state before we enable the irqs */
-	hcd->state = HC_STATE_RUNNING;
 	temp = xhci_readl(xhci, &xhci->op_regs->command);
 	temp |= (CMD_EIE);
 	xhci_dbg(xhci, "// Enable interrupts, cmd = 0x%x.\n",