spi: Setup the master controller driver before setting the chipselect

SPI controllers may need to be properly setup before chip selects
can be used. Therefore, wait until the spi controller has a chance
to perform their setup procedure before trying to use the chip
select.

This also insures that the chip selects pins are in a good
state before asseting them which otherwise may cause confusion.
Signed-off-by: NFranklin S Cooper Jr <fcooper@ti.com>
Tested-by: NGrygorii Strashko <grygorii.strashko@ti.com>
Tested-by: NIvan Khoronzhuk <ivan.khoronzhuk@linaro.org>
Signed-off-by: NMark Brown <broonie@kernel.org>

drivers/spi/spi.c

@@ -1993,11 +1993,11 @@ int spi_setup(struct spi_device *spi)
 	if (!spi->max_speed_hz)
 		spi->max_speed_hz = spi->master->max_speed_hz;
 
-	spi_set_cs(spi, false);
-
 	if (spi->master->setup)
 		status = spi->master->setup(spi);
 
+	spi_set_cs(spi, false);
+
 	dev_dbg(&spi->dev, "setup mode %d, %s%s%s%s%u bits/w, %u Hz max --> %d\n",
 			(int) (spi->mode & (SPI_CPOL | SPI_CPHA)),
 			(spi->mode & SPI_CS_HIGH) ? "cs_high, " : "",