V4L/DVB (7726): cx23885: Enable cx23417 support on the HVR1800

cx23885: Enable cx23417 support on the HVR1800
Signed-off-by: NSteven Toth <stoth@hauppauge.com>
Signed-off-by: NMichael Krufky <mkrufky@linuxtv.org>
Signed-off-by: NMauro Carvalho Chehab <mchehab@infradead.org>

drivers/media/video/cx23885/cx23885-cards.c

@@ -73,6 +73,7 @@ struct cx23885_board cx23885_boards[] = {
 	[CX23885_BOARD_HAUPPAUGE_HVR1800] = {
 		.name		= "Hauppauge WinTV-HVR1800",
 		.porta		= CX23885_ANALOG_VIDEO,
+		.portb		= CX23885_MPEG_ENCODER,
 		.portc		= CX23885_MPEG_DVB,
 		.tuner_type	= TUNER_PHILIPS_TDA8290,
 		.tuner_addr	= 0x42, /* 0x84 >> 1 */
@@ -336,6 +337,10 @@ void cx23885_gpio_setup(struct cx23885_dev *dev)
 		/* GPIO-15-18 cx23417 READY, CS, RD, WR */
 		/* GPIO-19 IR_RX */
 
+		/* CX23417 GPIO's */
+		/* EIO15 Zilog Reset */
+		/* EIO14 S5H1409/CX24227 Reset */
+
 		/* Force the TDA8295A into reset and back */
 		cx_set(GP0_IO, 0x00040004);
 		mdelay(20);
@@ -443,10 +448,25 @@ void cx23885_card_setup(struct cx23885_dev *dev)
 		ts1->ts_clk_en_val = 0x1; /* Enable TS_CLK */
 		ts1->src_sel_val   = CX23885_SRC_SEL_PARALLEL_MPEG_VIDEO;
 		break;
+	case CX23885_BOARD_HAUPPAUGE_HVR1800:
+		/* Defaults for VID B - Analog encoder */
+		/* DREQ_POL, SMODE, PUNC_CLK, MCLK_POL Serial bus + punc clk */
+		ts1->gen_ctrl_val    = 0x10e;
+		ts1->ts_clk_en_val   = 0x1; /* Enable TS_CLK */
+		ts1->src_sel_val     = CX23885_SRC_SEL_PARALLEL_MPEG_VIDEO;
+
+		/* APB_TSVALERR_POL (active low)*/
+		ts1->vld_misc_val    = 0x2000;
+		ts1->hw_sop_ctrl_val = (0x47 << 16 | 188 << 4 | 0xc);
+
+		/* Defaults for VID C */
+		ts2->gen_ctrl_val  = 0xc; /* Serial bus + punctured clock */
+		ts2->ts_clk_en_val = 0x1; /* Enable TS_CLK */
+		ts2->src_sel_val   = CX23885_SRC_SEL_PARALLEL_MPEG_VIDEO;
+		break;
 	case CX23885_BOARD_HAUPPAUGE_HVR1250:
 	case CX23885_BOARD_HAUPPAUGE_HVR1500:
 	case CX23885_BOARD_HAUPPAUGE_HVR1500Q:
-	case CX23885_BOARD_HAUPPAUGE_HVR1800:
 	case CX23885_BOARD_HAUPPAUGE_HVR1800lp:
 	case CX23885_BOARD_HAUPPAUGE_HVR1200:
 	case CX23885_BOARD_HAUPPAUGE_HVR1700:

drivers/media/video/cx23885/cx23885-core.c

@@ -1037,6 +1037,7 @@ static int cx23885_start_dma(struct cx23885_tsport *port,
 			     struct cx23885_buffer   *buf)
 {
 	struct cx23885_dev *dev = port->dev;
+	u32 reg;
 
 	dprintk(1, "%s() w: %d, h: %d, f: %d\n", __func__,
 		buf->vb.width, buf->vb.height, buf->vb.field);
@@ -1062,6 +1063,9 @@ static int cx23885_start_dma(struct cx23885_tsport *port,
 		return -EINVAL;
 	}
 
+	if (cx23885_boards[dev->board].portb == CX23885_MPEG_ENCODER)
+		cx23885_av_clk(dev, 0);
+
 	udelay(100);
 
 	/* If the port supports SRC SELECT, configure it */
@@ -1079,6 +1083,21 @@ static int cx23885_start_dma(struct cx23885_tsport *port,
 	cx_write(port->reg_gpcnt_ctl, 3);
 	q->count = 1;
 
+	if (cx23885_boards[dev->board].portb & CX23885_MPEG_ENCODER) {
+
+		reg = cx_read(PAD_CTRL);
+		reg = reg & ~0x1;    /* Clear TS1_OE */
+
+		/* FIXME, bit 2 writing here is questionable */
+		/* set TS1_SOP_OE and TS1_OE_HI */
+		reg = reg | 0xa;
+		cx_write(PAD_CTRL, reg);
+
+		/* FIXME and these two registers should be documented. */
+		cx_write(CLK_DELAY, cx_read(CLK_DELAY) | 0x80000011);
+		cx_write(ALT_PIN_OUT_SEL, 0x10100045);
+	}
+
 	switch(dev->bridge) {
 	case CX23885_BRIDGE_885:
 	case CX23885_BRIDGE_887:
@@ -1094,6 +1113,9 @@ static int cx23885_start_dma(struct cx23885_tsport *port,
 
 	cx_set(DEV_CNTRL2, (1<<5)); /* Enable RISC controller */
 
+	if (cx23885_boards[dev->board].portb == CX23885_MPEG_ENCODER)
+		cx23885_av_clk(dev, 1);
+
 	if (debug > 4)
 		cx23885_tsport_reg_dump(port);
 
@@ -1103,12 +1125,32 @@ static int cx23885_start_dma(struct cx23885_tsport *port,
 static int cx23885_stop_dma(struct cx23885_tsport *port)
 {
 	struct cx23885_dev *dev = port->dev;
+	u32 reg;
+
 	dprintk(1, "%s()\n", __func__);
 
 	/* Stop interrupts and DMA */
 	cx_clear(port->reg_ts_int_msk, port->ts_int_msk_val);
 	cx_clear(port->reg_dma_ctl, port->dma_ctl_val);
 
+	if (cx23885_boards[dev->board].portb & CX23885_MPEG_ENCODER) {
+
+		reg = cx_read(PAD_CTRL);
+
+		/* Set TS1_OE */
+		reg = reg | 0x1;
+
+		/* clear TS1_SOP_OE and TS1_OE_HI */
+		reg = reg & ~0xa;
+		cx_write(PAD_CTRL, reg);
+		cx_write(port->reg_src_sel, 0);
+		cx_write(port->reg_gen_ctrl, 8);
+
+	}
+
+	if (cx23885_boards[dev->board].portb == CX23885_MPEG_ENCODER)
+		cx23885_av_clk(dev, 0);
+
 	return 0;
 }
 
@@ -1525,7 +1567,8 @@ static int __devinit cx23885_initdev(struct pci_dev *pci_dev,
 	printk(KERN_INFO "%s/0: found at %s, rev: %d, irq: %d, "
 	       "latency: %d, mmio: 0x%llx\n", dev->name,
 	       pci_name(pci_dev), dev->pci_rev, pci_dev->irq,
-	       dev->pci_lat, (unsigned long long)pci_resource_start(pci_dev,0));
+	       dev->pci_lat,
+		(unsigned long long)pci_resource_start(pci_dev, 0));
 
 	pci_set_master(pci_dev);
 	if (!pci_dma_supported(pci_dev, 0xffffffff)) {

drivers/media/video/cx23885/cx23885-i2c.c

@@ -423,6 +423,29 @@ int cx23885_i2c_unregister(struct cx23885_i2c *bus)
 	return 0;
 }
 
+void cx23885_av_clk(struct cx23885_dev *dev, int enable)
+{
+	/* write 0 to bus 2 addr 0x144 via i2x_xfer() */
+	char buffer[3];
+	struct i2c_msg msg;
+	dprintk(1, "%s(enabled = %d)\n", __func__, enable);
+
+	/* Register 0x144 */
+	buffer[0] = 0x01;
+	buffer[1] = 0x44;
+	if (enable == 1)
+		buffer[2] = 0x05;
+	else
+		buffer[2] = 0x00;
+
+	msg.addr = 0x44;
+	msg.flags = I2C_M_TEN;
+	msg.len = 3;
+	msg.buf = buffer;
+
+	i2c_xfer(&dev->i2c_bus[2].i2c_adap, &msg, 1);
+}
+
 /* ----------------------------------------------------------------------- */
 
 /*

drivers/media/video/cx23885/cx23885.h

@@ -446,6 +446,7 @@ extern int cx23885_i2c_register(struct cx23885_i2c *bus);
 extern int cx23885_i2c_unregister(struct cx23885_i2c *bus);
 extern void cx23885_call_i2c_clients(struct cx23885_i2c *bus, unsigned int cmd,
 				     void *arg);
+extern void cx23885_av_clk(struct cx23885_dev *dev, int enable);
 
 /* ----------------------------------------------------------- */
 /* cx23885-417.c                                               */