dma-direct: always allow dma mask <= physiscal memory size

This way an architecture with less than 4G of RAM can support dma_mask
smaller than 32-bit without a ZONE_DMA.  Apparently that is a common
case on powerpc.
Signed-off-by: NChristoph Hellwig <hch@lst.de>
Reviewed-by: NRobin Murphy <robin.murphy@arm.com>

kernel/dma/direct.c

@@ -284,21 +284,25 @@ int dma_direct_map_sg(struct device *dev, struct scatterlist *sgl, int nents,
 	return nents;
 }
 
+/*
+ * Because 32-bit DMA masks are so common we expect every architecture to be
+ * able to satisfy them - either by not supporting more physical memory, or by
+ * providing a ZONE_DMA32.  If neither is the case, the architecture needs to
+ * use an IOMMU instead of the direct mapping.
+ */
 int dma_direct_supported(struct device *dev, u64 mask)
 {
-#ifdef CONFIG_ZONE_DMA
-	if (mask < phys_to_dma(dev, DMA_BIT_MASK(ARCH_ZONE_DMA_BITS)))
-		return 0;
-#else
-	/*
-	 * Because 32-bit DMA masks are so common we expect every architecture
-	 * to be able to satisfy them - either by not supporting more physical
-	 * memory, or by providing a ZONE_DMA32.  If neither is the case, the
-	 * architecture needs to use an IOMMU instead of the direct mapping.
-	 */
-	if (mask < phys_to_dma(dev, DMA_BIT_MASK(32)))
+	u64 min_mask;
+
+	if (IS_ENABLED(CONFIG_ZONE_DMA))
+		min_mask = DMA_BIT_MASK(ARCH_ZONE_DMA_BITS);
+	else
+		min_mask = DMA_BIT_MASK(32);
+
+	min_mask = min_t(u64, min_mask, (max_pfn - 1) << PAGE_SHIFT);
+
+	if (mask >= phys_to_dma(dev, min_mask))
 		return 0;
-#endif
 	return 1;
 }