net: hns3: Add support to enable TX/RX promisc mode for H/W rev(0x21)

HCLGE_PROMISC_TX_EN_B and HCLGE_PROMISC_RX_EN_B are not supported
on pdev revision(0x20), new revision(0x21) supports them.
Signed-off-by: NPeng Li <lipeng321@huawei.com>
Signed-off-by: NSalil Mehta <salil.mehta@huawei.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

drivers/net/ethernet/hisilicon/hns3/hns3pf/hclge_cmd.h

@@ -484,6 +484,8 @@ struct hclge_promisc_param {
 	u8 enable;
 };
 
+#define HCLGE_PROMISC_TX_EN_B	BIT(4)
+#define HCLGE_PROMISC_RX_EN_B	BIT(5)
 #define HCLGE_PROMISC_EN_B	1
 #define HCLGE_PROMISC_EN_ALL	0x7
 #define HCLGE_PROMISC_EN_UC	0x1

drivers/net/ethernet/hisilicon/hns3/hns3pf/hclge_main.c

@@ -3586,7 +3586,14 @@ int hclge_cmd_set_promisc_mode(struct hclge_dev *hdev,
 
 	req = (struct hclge_promisc_cfg_cmd *)desc.data;
 	req->vf_id = param->vf_id;
-	req->flag = (param->enable << HCLGE_PROMISC_EN_B);
+
+	/* HCLGE_PROMISC_TX_EN_B and HCLGE_PROMISC_RX_EN_B are not supported on
+	 * pdev revision(0x20), new revision support them. The
+	 * value of this two fields will not return error when driver
+	 * send command to fireware in revision(0x20).
+	 */
+	req->flag = (param->enable << HCLGE_PROMISC_EN_B) |
+		HCLGE_PROMISC_TX_EN_B | HCLGE_PROMISC_RX_EN_B;
 
 	ret = hclge_cmd_send(&hdev->hw, &desc, 1);
 	if (ret) {