tipc: improve TIPC throughput by Gap ACK blocks
During unicast link transmission, it's observed very often that because of one or a few lost/dis-ordered packets, the sending side will fastly reach the send window limit and must wait for the packets to be arrived at the receiving side or in the worst case, a retransmission must be done first. The sending side cannot release a lot of subsequent packets in its transmq even though all of them might have already been received by the receiving side. That is, one or two packets dis-ordered/lost and dozens of packets have to wait, this obviously reduces the overall throughput! This commit introduces an algorithm to overcome this by using "Gap ACK blocks". Basically, a Gap ACK block will consist of <ack, gap> numbers that describes the link deferdq where packets have been got by the receiving side but with gaps, for example: link deferdq: [1 2 3 4 10 11 13 14 15 20] --> Gap ACK blocks: <4, 5>, <11, 1>, <15, 4>, <20, 0> The Gap ACK blocks will be sent to the sending side along with the traditional ACK or NACK message. Immediately when receiving the message the sending side will now not only release from its transmq the packets ack-ed by the ACK but also by the Gap ACK blocks! So, more packets can be enqueued and transmitted. In addition, the sending side can now do "multi-retransmissions" according to the Gaps reported in the Gap ACK blocks. The new algorithm as verified helps greatly improve the TIPC throughput especially under packet loss condition. So far, a maximum of 32 blocks is quite enough without any "Too few Gap ACK blocks" reports with a 5.0% packet loss rate, however this number can be increased in the furture if needed. Also, the patch is backward compatible. Acked-by: NYing Xue <ying.xue@windriver.com> Acked-by: NJon Maloy <jon.maloy@ericsson.com> Signed-off-by: NTuong Lien <tuong.t.lien@dektech.com.au> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
Showing
想要评论请 注册 或 登录