stmmac: do not poll phy handler when attach a switch

This patch avoids to call the stmmac_adjust_link when
the driver is connected to a switch by using the FIXED_PHY
support. Prior this patch the phydev->irq was set as PHY_POLL
so periodically the phy handler was invoked spending useless
time because the link cannot actually change.
Note that the stmmac_adjust_link will be called just one
time and this guarantees that the ST glue logic will be
setup according to the mode and speed fixed.
Signed-off-by: NGiuseppe Cavallaro <peppe.cavallaro@st.com>
Signed-off-by: NAlexandre TORGUE <alexandre.torgue@st.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

drivers/net/ethernet/stmicro/stmmac/stmmac_main.c

@@ -866,6 +866,11 @@ static int stmmac_init_phy(struct net_device *dev)
 		phy_disconnect(phydev);
 		return -ENODEV;
 	}
+
+	/* If attached to a switch, there is no reason to poll phy handler */
+	if (!strcmp(priv->plat->phy_bus_name, "fixed"))
+		phydev->irq = PHY_IGNORE_INTERRUPT;
+
 	pr_debug("stmmac_init_phy:  %s: attached to PHY (UID 0x%x)"
 		 " Link = %d\n", dev->name, phydev->phy_id, phydev->link);