提交 8e5368a1 编写于 作者: D David Woodhouse

[MTD] [NAND] Remember timing settings for CAFÉ NAND controller.

We'll need them for suspend/resume.
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>
上级 3a6effe8
......@@ -530,7 +530,6 @@ static int __devinit cafe_nand_probe(struct pci_dev *pdev,
{
struct mtd_info *mtd;
struct cafe_priv *cafe;
uint32_t timing1, timing2, timing3;
uint32_t ctrl;
int err = 0;
......@@ -587,21 +586,19 @@ static int __devinit cafe_nand_probe(struct pci_dev *pdev,
}
if (numtimings == 3) {
timing1 = timing[0];
timing2 = timing[1];
timing3 = timing[2];
cafe_dev_dbg(&cafe->pdev->dev, "Using provided timings (%08x %08x %08x)\n",
timing1, timing2, timing3);
timing[0], timing[1], timing[2]);
} else {
timing1 = cafe_readl(cafe, NAND_TIMING1);
timing2 = cafe_readl(cafe, NAND_TIMING2);
timing3 = cafe_readl(cafe, NAND_TIMING3);
timing[0] = cafe_readl(cafe, NAND_TIMING1);
timing[1] = cafe_readl(cafe, NAND_TIMING2);
timing[2] = cafe_readl(cafe, NAND_TIMING3);
if (timing1 | timing2 | timing3) {
cafe_dev_dbg(&cafe->pdev->dev, "Timing registers already set (%08x %08x %08x)\n", timing1, timing2, timing3);
if (timing[0] | timing[1] | timing[2]) {
cafe_dev_dbg(&cafe->pdev->dev, "Timing registers already set (%08x %08x %08x)\n",
timing[0], timing[1], timing[2]);
} else {
dev_warn(&cafe->pdev->dev, "Timing registers unset; using most conservative defaults\n");
timing1 = timing2 = timing3 = 0xffffffff;
timing[0] = timing[1] = timing[2] = 0xffffffff;
}
}
......@@ -609,9 +606,9 @@ static int __devinit cafe_nand_probe(struct pci_dev *pdev,
cafe_writel(cafe, 1, NAND_RESET);
cafe_writel(cafe, 0, NAND_RESET);
cafe_writel(cafe, timing1, NAND_TIMING1);
cafe_writel(cafe, timing2, NAND_TIMING2);
cafe_writel(cafe, timing3, NAND_TIMING3);
cafe_writel(cafe, timing[0], NAND_TIMING1);
cafe_writel(cafe, timing[1], NAND_TIMING2);
cafe_writel(cafe, timing[2], NAND_TIMING3);
cafe_writel(cafe, 0xffffffff, NAND_IRQ_MASK);
err = request_irq(pdev->irq, &cafe_nand_interrupt, IRQF_SHARED,
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册