提交 839554b7 编写于 作者: D David S. Miller

Merge branch 'Rework-mt762x-GDM-setup-flow'

MarkLee says:

====================
Rework mt762x GDM setup flow

The mt762x GDM block is mainly used to setup the HW internal
rx path from GMAC to RX DMA engine(PDMA) and the packet
switching engine(PSE) is responsed to do the data forward
following the GDM configuration.

This patch set have three goals :

1. Integrate GDM/PSE setup operations into single function "mtk_gdm_config"

2. Refine the timing of GDM/PSE setup, move it from mtk_hw_init
   to mtk_open

3. Enable GDM GDMA_DROP_ALL mode to drop all packet during the
   stop operation
====================
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
......@@ -2180,6 +2180,31 @@ static int mtk_start_dma(struct mtk_eth *eth)
return 0;
}
static void mtk_gdm_config(struct mtk_eth *eth, u32 config)
{
int i;
if (MTK_HAS_CAPS(eth->soc->caps, MTK_SOC_MT7628))
return;
for (i = 0; i < MTK_MAC_COUNT; i++) {
u32 val = mtk_r32(eth, MTK_GDMA_FWD_CFG(i));
/* default setup the forward port to send frame to PDMA */
val &= ~0xffff;
/* Enable RX checksum */
val |= MTK_GDMA_ICS_EN | MTK_GDMA_TCS_EN | MTK_GDMA_UCS_EN;
val |= config;
mtk_w32(eth, val, MTK_GDMA_FWD_CFG(i));
}
/* Reset and enable PSE */
mtk_w32(eth, RST_GL_PSE, MTK_RST_GL);
mtk_w32(eth, 0, MTK_RST_GL);
}
static int mtk_open(struct net_device *dev)
{
struct mtk_mac *mac = netdev_priv(dev);
......@@ -2200,6 +2225,8 @@ static int mtk_open(struct net_device *dev)
if (err)
return err;
mtk_gdm_config(eth, MTK_GDMA_TO_PDMA);
napi_enable(&eth->tx_napi);
napi_enable(&eth->rx_napi);
mtk_tx_irq_enable(eth, MTK_TX_DONE_INT);
......@@ -2252,6 +2279,8 @@ static int mtk_stop(struct net_device *dev)
if (!refcount_dec_and_test(&eth->dma_refcnt))
return 0;
mtk_gdm_config(eth, MTK_GDMA_DROP_ALL);
mtk_tx_irq_disable(eth, MTK_TX_DONE_INT);
mtk_rx_irq_disable(eth, MTK_RX_DONE_INT);
napi_disable(&eth->tx_napi);
......@@ -2375,8 +2404,6 @@ static int mtk_hw_init(struct mtk_eth *eth)
mtk_w32(eth, 0, MTK_QDMA_DELAY_INT);
mtk_tx_irq_disable(eth, ~0);
mtk_rx_irq_disable(eth, ~0);
mtk_w32(eth, RST_GL_PSE, MTK_RST_GL);
mtk_w32(eth, 0, MTK_RST_GL);
/* FE int grouping */
mtk_w32(eth, MTK_TX_DONE_INT, MTK_PDMA_INT_GRP1);
......@@ -2385,19 +2412,6 @@ static int mtk_hw_init(struct mtk_eth *eth)
mtk_w32(eth, MTK_RX_DONE_INT, MTK_QDMA_INT_GRP2);
mtk_w32(eth, 0x21021000, MTK_FE_INT_GRP);
for (i = 0; i < MTK_MAC_COUNT; i++) {
u32 val = mtk_r32(eth, MTK_GDMA_FWD_CFG(i));
/* setup the forward port to send frame to PDMA */
val &= ~0xffff;
/* Enable RX checksum */
val |= MTK_GDMA_ICS_EN | MTK_GDMA_TCS_EN | MTK_GDMA_UCS_EN;
/* setup the mac dma */
mtk_w32(eth, val, MTK_GDMA_FWD_CFG(i));
}
return 0;
err_disable_pm:
......
......@@ -84,6 +84,8 @@
#define MTK_GDMA_ICS_EN BIT(22)
#define MTK_GDMA_TCS_EN BIT(21)
#define MTK_GDMA_UCS_EN BIT(20)
#define MTK_GDMA_TO_PDMA 0x0
#define MTK_GDMA_DROP_ALL 0x7777
/* Unicast Filter MAC Address Register - Low */
#define MTK_GDMA_MAC_ADRL(x) (0x508 + (x * 0x1000))
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册