提交 703cb2cb 编写于 作者: A Adrian Bunk 提交者: Mauro Carvalho Chehab

V4L/DVB (3428): drivers/media/dvb/ possible cleanups

- Make needlessly global code static
- #if 0 the following unused global functions:
- b2c2/flexcop-dma.c: flexcop_dma_control_packet_irq()
- b2c2/flexcop-dma.c: flexcop_dma_config_packet_count()
Signed-off-by: NAdrian Bunk <bunk@stusta.de>
Signed-off-by: NPatrick Boettcher <pb@linuxtv.org>
Signed-off-by: NMichael Krufky <mkrufky@m1k.net>
Signed-off-by: NMauro Carvalho Chehab <mchehab@infradead.org>
上级 8a4b275f
......@@ -116,11 +116,9 @@ void flexcop_dma_free(struct flexcop_dma *dma);
int flexcop_dma_control_timer_irq(struct flexcop_device *fc, flexcop_dma_index_t no, int onoff);
int flexcop_dma_control_size_irq(struct flexcop_device *fc, flexcop_dma_index_t no, int onoff);
int flexcop_dma_control_packet_irq(struct flexcop_device *fc, flexcop_dma_index_t no, int onoff);
int flexcop_dma_config(struct flexcop_device *fc, struct flexcop_dma *dma, flexcop_dma_index_t dma_idx);
int flexcop_dma_xfer_control(struct flexcop_device *fc, flexcop_dma_index_t dma_idx, flexcop_dma_addr_index_t index, int onoff);
int flexcop_dma_config_timer(struct flexcop_device *fc, flexcop_dma_index_t dma_idx, u8 cycles);
int flexcop_dma_config_packet_count(struct flexcop_device *fc, flexcop_dma_index_t dma_idx, u8 packets);
/* from flexcop-eeprom.c */
/* the PCI part uses this call to get the MAC address, the USB part has its own */
......
......@@ -169,38 +169,3 @@ int flexcop_dma_config_timer(struct flexcop_device *fc,
}
EXPORT_SYMBOL(flexcop_dma_config_timer);
/* packet IRQ does not exist in FCII or FCIIb - according to data book and tests */
int flexcop_dma_control_packet_irq(struct flexcop_device *fc,
flexcop_dma_index_t no,
int onoff)
{
flexcop_ibi_value v = fc->read_ibi_reg(fc,ctrl_208);
deb_rdump("reg: %03x: %x\n",ctrl_208,v.raw);
if (no & FC_DMA_1)
v.ctrl_208.DMA1_Size_IRQ_Enable_sig = onoff;
if (no & FC_DMA_2)
v.ctrl_208.DMA2_Size_IRQ_Enable_sig = onoff;
fc->write_ibi_reg(fc,ctrl_208,v);
deb_rdump("reg: %03x: %x\n",ctrl_208,v.raw);
return 0;
}
EXPORT_SYMBOL(flexcop_dma_control_packet_irq);
int flexcop_dma_config_packet_count(struct flexcop_device *fc,
flexcop_dma_index_t dma_idx,
u8 packets)
{
flexcop_ibi_register r = (dma_idx & FC_DMA_1) ? dma1_004 : dma2_014;
flexcop_ibi_value v = fc->read_ibi_reg(fc,r);
flexcop_dma_remap(fc,dma_idx,1);
v.dma_0x4_remap.DMA_maxpackets = packets;
fc->write_ibi_reg(fc,r,v);
return 0;
}
EXPORT_SYMBOL(flexcop_dma_config_packet_count);
......@@ -36,14 +36,14 @@ void flexcop_determine_revision(struct flexcop_device *fc)
/* bus parts have to decide if hw pid filtering is used or not. */
}
const char *flexcop_revision_names[] = {
static const char *flexcop_revision_names[] = {
"Unkown chip",
"FlexCopII",
"FlexCopIIb",
"FlexCopIII",
};
const char *flexcop_device_names[] = {
static const char *flexcop_device_names[] = {
"Unkown device",
"Air2PC/AirStar 2 DVB-T",
"Air2PC/AirStar 2 ATSC 1st generation",
......@@ -54,7 +54,7 @@ const char *flexcop_device_names[] = {
"Air2PC/AirStar 2 ATSC 3rd generation (HD5000)",
};
const char *flexcop_bus_names[] = {
static const char *flexcop_bus_names[] = {
"USB",
"PCI",
};
......
......@@ -16,8 +16,6 @@ typedef enum {
FLEXCOP_III,
} flexcop_revision_t;
extern const char *flexcop_revision_names[];
typedef enum {
FC_UNK = 0,
FC_AIR_DVB,
......@@ -34,8 +32,6 @@ typedef enum {
FC_PCI,
} flexcop_bus_t;
extern const char *flexcop_device_names[];
/* FlexCop IBI Registers */
#if defined(__LITTLE_ENDIAN)
#include "flexcop_ibi_value_le.h"
......
......@@ -184,7 +184,7 @@ static int cxusb_rc_query(struct dvb_usb_device *d, u32 *event, int *state)
return 0;
}
struct dvb_usb_rc_key dvico_mce_rc_keys[] = {
static struct dvb_usb_rc_key dvico_mce_rc_keys[] = {
{ 0xfe, 0x02, KEY_TV },
{ 0xfe, 0x0e, KEY_MP3 },
{ 0xfe, 0x1a, KEY_DVD },
......@@ -273,7 +273,7 @@ static int cxusb_mt352_demod_init(struct dvb_frontend* fe)
return 0;
}
struct cx22702_config cxusb_cx22702_config = {
static struct cx22702_config cxusb_cx22702_config = {
.demod_address = 0x63,
.output_mode = CX22702_PARALLEL_OUTPUT,
......@@ -282,13 +282,13 @@ struct cx22702_config cxusb_cx22702_config = {
.pll_set = dvb_usb_pll_set_i2c,
};
struct lgdt330x_config cxusb_lgdt330x_config = {
static struct lgdt330x_config cxusb_lgdt330x_config = {
.demod_address = 0x0e,
.demod_chip = LGDT3303,
.pll_set = dvb_usb_pll_set_i2c,
};
struct mt352_config cxusb_dee1601_config = {
static struct mt352_config cxusb_dee1601_config = {
.demod_address = 0x0f,
.demod_init = cxusb_dee1601_demod_init,
.pll_set = dvb_usb_pll_set,
......
......@@ -24,6 +24,9 @@ static struct usb_cypress_controller cypress[] = {
{ .id = CYPRESS_FX2, .name = "Cypress FX2", .cpu_cs_register = 0xe600 },
};
static int dvb_usb_get_hexline(const struct firmware *fw, struct hexline *hx,
int *pos);
/*
* load a firmware packet to the device
*/
......@@ -112,7 +115,8 @@ int dvb_usb_download_firmware(struct usb_device *udev, struct dvb_usb_properties
return ret;
}
int dvb_usb_get_hexline(const struct firmware *fw, struct hexline *hx, int *pos)
static int dvb_usb_get_hexline(const struct firmware *fw, struct hexline *hx,
int *pos)
{
u8 *b = (u8 *) &fw->data[*pos];
int data_offs = 4;
......@@ -142,5 +146,3 @@ int dvb_usb_get_hexline(const struct firmware *fw, struct hexline *hx, int *pos)
return *pos;
}
EXPORT_SYMBOL(dvb_usb_get_hexline);
......@@ -341,7 +341,6 @@ struct hexline {
u8 data[255];
u8 chk;
};
extern int dvb_usb_get_hexline(const struct firmware *, struct hexline *, int *);
extern int usb_cypress_load_firmware(struct usb_device *udev, const struct firmware *fw, int type);
#endif
......@@ -53,7 +53,8 @@ int vp702x_usb_in_op(struct dvb_usb_device *d, u8 req, u16 value, u16 index, u8
return ret;
}
int vp702x_usb_out_op(struct dvb_usb_device *d, u8 req, u16 value, u16 index, u8 *b, int blen)
static int vp702x_usb_out_op(struct dvb_usb_device *d, u8 req, u16 value,
u16 index, u8 *b, int blen)
{
deb_xfer("out: req. %x, val: %x, ind: %x, buffer: ",req,value,index);
debug_dump(b,blen,deb_xfer);
......@@ -88,7 +89,8 @@ int vp702x_usb_inout_op(struct dvb_usb_device *d, u8 *o, int olen, u8 *i, int il
return ret;
}
int vp702x_usb_inout_cmd(struct dvb_usb_device *d, u8 cmd, u8 *o, int olen, u8 *i, int ilen, int msec)
static int vp702x_usb_inout_cmd(struct dvb_usb_device *d, u8 cmd, u8 *o,
int olen, u8 *i, int ilen, int msec)
{
u8 bout[olen+2];
u8 bin[ilen+1];
......
......@@ -101,8 +101,6 @@ extern int dvb_usb_vp702x_debug;
extern struct dvb_frontend * vp702x_fe_attach(struct dvb_usb_device *d);
extern int vp702x_usb_inout_op(struct dvb_usb_device *d, u8 *o, int olen, u8 *i, int ilen, int msec);
extern int vp702x_usb_inout_cmd(struct dvb_usb_device *d, u8 cmd, u8 *o, int olen, u8 *i, int ilen, int msec);
extern int vp702x_usb_in_op(struct dvb_usb_device *d, u8 req, u16 value, u16 index, u8 *b, int blen);
extern int vp702x_usb_out_op(struct dvb_usb_device *d, u8 req, u16 value, u16 index, u8 *b, int blen);
#endif
......@@ -273,8 +273,6 @@ struct av7110 {
extern int ChangePIDs(struct av7110 *av7110, u16 vpid, u16 apid, u16 ttpid,
u16 subpid, u16 pcrpid);
extern int av7110_setup_irc_config (struct av7110 *av7110, u32 ir_config);
extern int av7110_ir_init(struct av7110 *av7110);
extern void av7110_ir_exit(struct av7110 *av7110);
......
......@@ -155,6 +155,19 @@ static void input_repeat_key(unsigned long data)
}
static int av7110_setup_irc_config(struct av7110 *av7110, u32 ir_config)
{
int ret = 0;
dprintk(4, "%p\n", av7110);
if (av7110) {
ret = av7110_fw_cmd(av7110, COMTYPE_PIDFILTER, SetIR, 1, ir_config);
av7110->ir_config = ir_config;
}
return ret;
}
static int av7110_ir_write_proc(struct file *file, const char __user *buffer,
unsigned long count, void *data)
{
......@@ -187,19 +200,6 @@ static int av7110_ir_write_proc(struct file *file, const char __user *buffer,
}
int av7110_setup_irc_config(struct av7110 *av7110, u32 ir_config)
{
int ret = 0;
dprintk(4, "%p\n", av7110);
if (av7110) {
ret = av7110_fw_cmd(av7110, COMTYPE_PIDFILTER, SetIR, 1, ir_config);
av7110->ir_config = ir_config;
}
return ret;
}
static void ir_handler(struct av7110 *av7110, u32 ircom)
{
dprintk(4, "ircommand = %08x\n", ircom);
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册