提交 6f2a6a52 编写于 作者: W Wolfram Sang 提交者: Artem Bityutskiy

mtd: nand: gpmi: reset BCH earlier, too, to avoid NAND startup problems

It could happen (1 out of 100 times) that NAND did not start up
correctly after warm rebooting, so the kernel could not find the UBI or
DMA timed out due to a stalled BCH. When resetting BCH together with
GPMI, the issue could not be observed anymore (after 10000+ reboots). We
probably need the consistent state already before sending any command to
NAND, even when no ECC is needed. I chose to keep the extra reset for
BCH when changing the flash layout to be on the safe side.
Signed-off-by: NWolfram Sang <w.sang@pengutronix.de>
Acked-by: NHuang Shijie <b32955@freescale.com>
Cc: stable@vger.kernel.org
Signed-off-by: NArtem Bityutskiy <artem.bityutskiy@linux.intel.com>
上级 3c9c6d65
......@@ -165,6 +165,15 @@ int gpmi_init(struct gpmi_nand_data *this)
if (ret)
goto err_out;
/*
* Reset BCH here, too. We got failures otherwise :(
* See later BCH reset for explanation of MX23 handling
*/
ret = gpmi_reset_block(r->bch_regs, GPMI_IS_MX23(this));
if (ret)
goto err_out;
/* Choose NAND mode. */
writel(BM_GPMI_CTRL1_GPMI_MODE, r->gpmi_regs + HW_GPMI_CTRL1_CLR);
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册