[SCSI] remove check for 'resetting'

Field is now unused, so this is dead code.

[jejb: remove resetting and last_reset from Scsi_Host]
Signed-off-by: NHannes Reinecke <hare@suse.de>
Signed-off-by: NJames Bottomley <JBottomley@Parallels.com>

drivers/scsi/scsi.c

@@ -78,11 +78,6 @@ static void scsi_done(struct scsi_cmnd *cmd);
  * Definitions and constants.
  */
 
-#define MIN_RESET_DELAY (2*HZ)
-
-/* Do not call reset on error if we just did a reset within 15 sec. */
-#define MIN_RESET_PERIOD (15*HZ)
-
 /*
  * Note - the initial logging level can be set here to log events at boot time.
  * After the system is up, you may enable logging via the /proc interface.
@@ -658,7 +653,6 @@ EXPORT_SYMBOL(scsi_cmd_get_serial);
 int scsi_dispatch_cmd(struct scsi_cmnd *cmd)
 {
 	struct Scsi_Host *host = cmd->device->host;
-	unsigned long timeout;
 	int rtn = 0;
 
 	atomic_inc(&cmd->device->iorequest_cnt);
@@ -704,28 +698,6 @@ int scsi_dispatch_cmd(struct scsi_cmnd *cmd)
 			       (cmd->device->lun << 5 & 0xe0);
 	}
 
-	/*
-	 * We will wait MIN_RESET_DELAY clock ticks after the last reset so
-	 * we can avoid the drive not being ready.
-	 */
-	timeout = host->last_reset + MIN_RESET_DELAY;
-
-	if (host->resetting && time_before(jiffies, timeout)) {
-		int ticks_remaining = timeout - jiffies;
-		/*
-		 * NOTE: This may be executed from within an interrupt
-		 * handler!  This is bad, but for now, it'll do.  The irq
-		 * level of the interrupt handler has been masked out by the
-		 * platform dependent interrupt handling code already, so the
-		 * sti() here will not cause another call to the SCSI host's
-		 * interrupt handler (assuming there is one irq-level per
-		 * host).
-		 */
-		while (--ticks_remaining >= 0)
-			mdelay(1 + 999 / HZ);
-		host->resetting = 0;
-	}
-
 	scsi_log_send(cmd);
 
 	/*

include/scsi/scsi_host.h

@@ -598,8 +598,6 @@ struct Scsi_Host {
 	unsigned int host_eh_scheduled;    /* EH scheduled without command */
     
 	unsigned int host_no;  /* Used for IOCTL_GET_IDLUN, /proc/scsi et al. */
-	int resetting; /* if set, it means that last_reset is a valid value */
-	unsigned long last_reset;
 
 	/*
 	 * These three parameters can be used to allow for wide scsi,